Sunricher SR-2812B User manual

Wall Mounted RGBW DMX512 +RF Controller 09.2812UDR.04250
Click to play / pause the 10 built-in
effects, Press and hold down to
speed up/down the running effects
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Back side
19.4 mm
Touch color wheel, touch to
select R/G/B color
Press and hold down to save
color/effect; Click to recall the
saved
Click to select Warm White,
Natural White and Cool White
mixed by RGB colors
Click to switch on/off
Red channel:Click to turn off/on
Press and hold down to increase/
decrease light intensity
Blue channel:Click to turn off/on
Press and hold down to increase/
decrease light intensity
Green channel:Click to turn off/on
Press and hold down to increase/
decrease light intensity
White channel:Click to turn off/on
Press and hold down to increase/
decrease light intensity
Press and hold down to
increase/decrease light
intensity
43.58 mm
65.58 mm
DC Power input
DMX512 signal output
V- D+D-V+ GND
DC INPUT DMX OUTPUT
DMX512 Wall Panel
Controller
83.00 mm
Wiring diagram
12-24VDC
PSU
12V/24V/36V
CV PSU
V+
V-
OUTPUT
AC 100-240V
Output Signal DMX512 signal
Power Supply 12-24VDC
Power consumption < 20 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 75x120x29.1mm
• Touch sensitive
• Glass interface(white & black)
• Standard DMX512 Signal output
• Can send RF signal, control the RF receiver
• Radio frequency: 916.5MHz
• Control RGBW color
• Control 1 zone/area
• Waterproof grade: IP20
Product Data
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
V- D+D-V+ GND
DC IN PUT DMX O UTPUT
DMX512 Wa ll Pa nel
Contro lle r
D1 D1 D2 D 2
DMX512 Decoder
GND
whit e
0-5 0-9 0- 9
D1 D1 D2 D 2
DMX512 Decoder
GND
whit e
0-5 0-9 0- 9
Set DMX Address
Connec t wit h RGBW LED St rip
V+ V+
R- R-
G- G-
B- B-
W- W-
Connec t wit h RGBW LED St rip
V+ V+
R- R-
G- G-
B- B-
W- W-
One DMX master controller can control many DMX Decoders, set all DMX decoders' address as 001.
Note: one DMX Decoder has 4 channels, so it occupies 4 DMX addresses 001, 002, 003, 004.
Installation

Pair with RF receiver
Step 1:Click the “Learning Key” button on RF receiver or re-power on the
receiver three times continuously to set it into pairing status
Learning Key
RF LED Receiver
Step 2:Touch the color wheel, LED lights connected with the RF receiver
flicker once means the receiver is paired with the wall panel successfully.
1. Do wiring the wall panel & RF receiver according to wiring diagram (please refer to the instruction of RF receiver that
you would like to pair with)
2. Power on, then touch the button to turn on the controller, indicator of the controller turned blue