superbrightleds WPFC-R1 User manual

Full Cuto󰀨 LED Wall Pack
Important: Read all instructions prior to installation. WPFC-R1 and
WPFCCT-R1 Series
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 04/27/2021
User Manual
5yr
120–277 VAC Input
0–10 V Dimming
Safety and Notes
SpecicationsWiring Diagram
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Gray
Green
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Gray
Green
• Product should be installed and serviced by a certied electrician in accordance
with applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source and circuit
breakers are switched o󰀨 before performing any installation or wiring procedures.
• Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support the weight of the xture.
Failure to properly support xture may result in damage or injury, for which the
manufacturer does not assume responsibility.
Model WPFC-R1 and WPFCCT-R1
Operating Temperature -22°–113° F (-30°–45° C)
IP Rating IP65
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
Opening Fixture
WPFC-R1-50K40-LD
screws
1/8” Drill Bit

Full Cuto󰀨 LED Wall Pack
Important: Read all instructions prior to installation. WPFC-R1 and
WPFCCT-R1 Series
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 04/27/2021
User Manual
5yr
Installation
CCT Adjustment
1. Remove screws and swing front housing down.
2. Drill holes in rear housing for mounting.
Note: For junction box wiring, remove rear pipe plug and for conduit mounting remove one of the side plugs.
3. Measure and create mounting holes on wall as needed.
4. Apply gasket and mount rear housing.
5. Select desired CCT using internal switch.
6. With supply power o󰀨, connect wiring.
7. Resecure front housing to rear housing.
Junction Box Installation Conduit Installation
On equipped models, selectable CCT
can be set using the internal switch.
Make certain supply power is switched
o󰀨 when performing this procedure.
screws
1/8” Drill Bit