TANDBERG 3000 MXP Profile Quick start guide

Tandberg 3000 MXP
CONNECTING THE 3000 MXP INPUTS AND OUTPUTS
1. Connect Line Output B of the Vortex Device to the 3000 MXP codec mixer Input 3 as
shown below using the attached RCA cable.
2. Connect Line Input B of the Vortex Device to one side of an RCA Y (one male to two
female) adapter connected to the Main line level Output 1 of the 3000 MXP codec as
shown below using the other attached RCA cable.
3. Connect the other side of the RCA Y adapter to the Audio or Speaker input of the
amplifier or video display to hear the far end audio using a RCA (male to male).
See next page for Tandberg settings.

To configure the Tandberg 6000 MVX system to use Revolabs DSP
Package microphones:
Go to Audio Settings.
Set Input 3 to MIC.
Confirm that Output 1 is ON.
Disable Echo Canceller (OFF).
Turn Audio Leveling (AGC) OFF.
Adjust the audio Input Type Level if necessary.
Speak into the Revolabs microphones that are connected to the audio line
inputs.
The audio meter should peak at about 5 dB for normal speech.