Target 4PC GALENA COUNTER HEIGHT SET 64414WHT User manual

Date: 7-SEPT-2016
ASSEMBLY INSTRUCTIONS
4PC GALENA COUNTER HEIGHT SET Item# 64414WHT
20 M nutes
Ph ll ps Screwdr ver
ASSEMBLY
2-Person Assembly T me Tools Requ red:
REQUIREMENTS:
Assembly
Per Item
(Not Prov ded)
Hammer/Mallet
(Approx mate)
Thank you for purchasing our product!
Please refer and use th s assembly nstruct on to assemble the product.
Contact our customer serv ce department n case there are any m ss ng or
damage parts or hardware. Replacement parts are normally sh pped
w th n 2 or 3 days.
Email: r plac m ntparts@buylat ral.com
Within 30 days from d liv ry dat
We apprec ate your bus ness!
ASSEMBLY PREPARATION
1. Remove all packag ng mater als, staples and pack ng straps from the carton.
2. Refer to Parts L st and Hardware L st and ensure they are complete before you start assembl ng.
3. Place all wooden parts on a clean, flat and soft surface (e.g. carpet or rug) to prevent parts from gett ng
scratched.
SAFETY PRECAUTION:
1. KEEP ALL HARDWARE PARTS OUT OF REACH OF CHILDREN.
2. DISPOSE PLASTIC PACKAGING MATERIAL IMMEDIATELY TO AVOID ANY RISK OF SUFFOCATION TO CHILDREN AND
ANIMALS.
TIPS FOR ASSEMBLY:
1. Allow ample room for assembly and n close prox m ty to where product w ll be placed.
2. Assemble the product on a surface that does not scratch or damage the exter or gloss and f n sh of the furn ture.
3. Please check all of the parts and quant t es are ncluded before assembly. Contact customer serv ce for m ss ng
parts.
4. Ident fy all of the parts, hardware and quant t es requ red for each step.
5. Dur ng assembly, do not over-t ghten any f tt ngs as th s may cause damage.
6. DO NOT USE POWER TOOLS TO ASSEMBLE THIS PRODUCT.
7. Always place the product on a flat surface.
8. Do not s t or stand on the part ally assembled product; only use the product for wh ch t s ntended.
CARE AND MAINTENANCE
• Use a sl ghtly damp cloth to clean the product. Do not use bleach or abras ve clean ng mater al.
• Check all the f tt ngs per od cally and re-t ghten as necessary. Do not use the product f any of the parts s
damaged or broken.
• Never allow any k nd of l qu d to rema n on your furn ture. Absorpt on can cause wood to warp or delam nate.
• Do not place hot tems (e.g. hot dr nks) d rectly onto the wood surface.
• Do not drag and/or pull the furn ture.
Th s product s for ndoor and household use only - not for commerc al use.
Page 1 of 6
MADE IN MALAYSIA

ASSEMBLY INSTRUCTIONS
4PC GALENA COUNTER HEIGHT SET Item# 64414WHT
Page 2 of 6

Identify and place all of the Table parts on a material that does not scratch or damage the parts.
a) Lay the Table Top (A) bottom-side up on a material that does not scratch or damage its surface.
b) Attach Table Short Crossbar (C) to Left Table Leg (B) and Right Table Leg (B) using Wood Screw (N).
c) Install Table Legs (B) to Table Top (A) by positioning each leg with bolt holes facing and align to the holes on
the comer block on the table frame. Next, insert JCBC Bolt (K) fitted with Spring Washer (L) and Flat Washer.
Use Allen Key (P) to tighten (K). Do not tighten (K) completely until all 4 bolts are in place.
Page 3 of 6