Teknion nuova contessa Owner's manual

nuova contessa adjustment features &
instructions
SEAT HEIGHT ADJUSTMENT BACK TILT ADJUSTMENT
4D ARM-WIDTH, DEPTH, PIVOT AND HEIGHT ADJUSTMENT
BACK TENSION ADJUSTMENT SEAT DEPTH ADJUSTMENT
Lifting the slide levers under both
sides of the seat allows it to be
adjusted forwards and backwards.
To adjust the width of the 4D arms,
grab the arm pad on both sides and
push to the left or to the right to the
desired position.
Simultaneously pivot the arm pad
inward or outward to the desired
angle. Arm pad depth can be
controlled by grabbing the pad and
sliding it forward or backward.
Back tilt adjustment
RIGHT
When the chair back is at the
desired angle, press the lever once
to lock it in position. Pressing the
lever again frees the chair back.
LEFT
Seat height can be adjusted by
lifting the lever at the front of
the right armrest. When this lever
is lifted, the weight of the body
will cause the seat to lower, and
releasing it stops the seat at the
desired height. Lifting the lever
with no weight on the seat allows
it to rise.
Back tilt adjustment
RIGHT
Turning the grip found under
the left side of the seat limits
the back tilt travel and locks
the back. Travel is limited on 3
positions with back lock in the
upright position.
To adjust the arm height, press
the button below either arm
rest to raise or lower it to the
desired position.
Back tilt adjustment
RIGHT
Back tilt adjustment
RIGHT
Back tilt adjustment
RIGHT
Back tilt adjustment
RIGHT
Back tilt adjustment
RIGHT
Back tilt adjustment
RIGHT
Back tilt adjustment
RIGHT
Back tilt adjustment
RIGHT

nuova contessa adjustment features &
instructions
LUMBAR HEIGHT ADJUSTMENT
The lumbar height-adjustment
levers can be found on either side
of the chair back frame.
The height of the lumbar support
can be adjusted by sliding it up
and down.
Lumbar responds uniquely to
user’s back curve depth and
pressure.
Back tilt adjustment
RIGHT
Warning
Tipping or collapsing can result in serious injury. To prevent product failure and possible injury:
• This chair has been designed and tested for users weighing up to 300 lbs
• Frequently inspect the chair for visible cracks and damages, tighten all screws, bolts, adjustable knobs and parts
• Do not use the chair if damaged or unstable – immediately remove it from service
• This chair is equipped with casters intended for use on carpeted surfaces. Use of these casters on hard surfaces could result in unexpected rolling and
tipping. Casters designed for use on hard surfaces are available. If in doubt, see your dealer for appropriate selection
• Do not stand on or use the chair as a step ladder
• Failure to follow these warnings could result in serious injury