Tennant 9018842 User manual

IB 9018922 (01- 2021) 1
INSTRUCTION BULLETIN
No. 9018922
Machine: M17/T17
Published: 01- 2021
Rev. 00
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9018842
Kit installation must be performed by TennantTrue

service or an authorized service provider.
SYNOPSIS:
This kit contains the parts needed to replace the pressure washer wand assembly on M17 sweeper
scrubbers and T17 scrubbers.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 30 minutes)
PROTECT THE ENVIRONMENT
Please dispose of packaging materials, used machine components
such as batteries and fluids in an environmentally safe way according
to local waste disposal regulations.
Always remember to recycle.
PREPARATION:
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
1. Disconnect the pressure washer wand
assembly from the pressure washer hose.
Discard the pressure washer wand assembly.
INSTALLATION:
1. Apply Teflontpipe sealant onto all threaded
surfaces of the wand (2) and the brass
straight fitting (3). (Fig. 1)
2. Assemble the pressure washer wand
assembly. (Fig. 1)
NOTE:To ensure a tight fit for all pressure washer
wand assembly threaded parts, use a vise to hold
the wand (2) when assembling threaded parts
onto the wand.
3. Connect the pressure washer wand assembly
to the pressure washer hose.
4. Turn on the machine and activate the
pressure washer system. Observe the
pressure washer wand assembly connections
and the wand connection to the pressure
washer hose for leaks. Repair leaks. Point the
pressure washer wand in a safe direction and
squeeze the trigger to ensure the pressure
washer wand assembly is functional.
5. Turn off the pressure washer system and
machine. Point the pressure washer wand in a
safe direction and squeeze the trigger to
release pressure from the system.
Teflon t is a registered trademark of the Chemours t Company.

IB 9018922 (01- 2021)2
1
2
5
3
4
Apply Teflon pipe sealant onto
all threaded surfaces.
FIG. 1
Bill Of Materials For Wand Kit, Press Wash, Afmkt [T/M17] - 9018842
Ref.
Tennant
Part No. Description Qty.
11039042 )Handle, Gun, Trigger 1
2 1039044 Wand, Str, SS, 28 1
3 1044428 Fitting, Brs, Str, PM04/PM06 [HP] 1
4 1042191 Fitting, SS, QDC, Mal 1
51238513 Nozzle, Press Washer 1
TENNANT COMPANY
P. O. Box 1452
Minneapolis, MN 55440-1452