TigerTough 182103 User manual

It’s not rocket science,
but following these
instrucons will make
installing your seat covers
a lot easier.
We promise.
182103 - Bucket Set

INSTALLATION GUIDE
185500 Rear Bench
Tesla Model Y

For assistance with installation, call us at 507.246.3545
BILL OF MATERIALS
ITEMITEM QUANTITY
Driver Side Seat Back Cover 1
Passenger Side Seat Back 1
Bench Bottom Cover 1
Center Console Cover 1
The Wierd Little Piece Below the Folding
Console
1
Headrest Cover 3
General care instructions:
1. In most cases dirt, debris, spills and pet hair can be removed by wiping with a
damp cloth.
2. Seat covers can be removed and machine washed on low temperature setting
using mild detergent.
Drip dry or machine tumble dry on a no heat cycle.
Straps should be coiled and secured with rubber bands for machine washing
and drying.
3. Soil may be removed with spray cleaner or detergent and water.
4. Oil or grease stains should rst be treated with a dry cleaning solvent followed
by a spray cleaner or detergent and water.
5. Do not use bleach.
Seat Backs & Bottoms have tags signifying Driver or Passenger.
Ensure airbag patch (same side as the TigerTough tag) goes on the outside edge of
the seat.
Watch the installation video at ttcovers.com/185500

For assistance with installation, call us at 507.246.3545
Your new seat covers are covered by a
two-year, unconditional, no B.S. warranty.
That means that if you manage to abuse
them to a point that they can’t perform like
they’re supposed to within two years of when
you bought them, we’ll make it right.
Depending on what is more practical, we’ll
either repair or replace the damaged cover.
Basically, you break it, we buy it.
Seriously.

For assistance with installation, call us at 507.246.3545
Remove Headrests
Remove headrests by pressing in the button on the side of the
one headrest mount and inserting a pick into the little hole on
the other. Pull up once released.

For assistance with installation, call us at 507.246.3545
Install Seat Bottom Cover
Remove seat
bottom cover from
the vehicle. Pull up
on the corners of
the bench bottom to
un-clip it.
Un-clip the one wire
connecting the seat
bottom to the frame.
Fasten the tabs as
shown.
Place cover over
seat bottom.
1
Undo all
velcro on the
seat back
cover. Line up
headrest mount
holes and
press the cover
around them.
Run cover
under the seat
belt.
Tip the middle
seat down so
the bar can be
put through the
hole in the cover
as shown. Push
the velcro ap at
the bottom of the
cover between
the back and the
bottom
Lastly, fasten
the ap across
the bottom.
Fold seatback
forward. Fasten
the velcro
together up and
down the back.
INSTALLATION IS BETTER SHOWN IN VIDEO
ttcovers.com/185500
2
3
4
5
6
7
8

For assistance with installation, call us at 507.246.3545
Seat Back
Fold the back
passenger’s side
seat down. Slid the
cover over like a
pillow case. Fasten
velcro at the back.
1
2
3
4
Slide cover over
the armrest
Put cover over
the littel piece
below the
cupholder. Push
the aps up
around behind
the seat.
Fasten aps as
shown.
Cover the regular
headrests.
Put the headrests
back on.
Put seat bottom
cover back in
place.
Cover the
middle seat
headrest.
5
6
7
8