TigerTough 34902 User manual

It’s not rocket science,
but following these
instrucons will make
installing your seat covers
a lot easier.
We promise.
34902 - Hino Passenger Bench

INSTALLATION GUIDE
34902 Passenger’s Bench
Hino 268 / 338

For assistance with installation, call us at 507.246.3545
BILL OF MATERIALS
ITEMITEM QUANTITY
Seat Back Cover 1
Seat Bottom Cover 1
StringLock 1
General care instructions:
1. In most cases dirt, debris, spills and pet hair can be removed by wiping with a
damp cloth.
2. Seat covers can be removed and machine washed on low temperature setting
using mild detergent.
Drip dry or machine tumble dry on a no heat cycle.
Straps should be coiled and secured with rubber bands for machine washing
and drying.
3. Soil may be removed with spray cleaner or detergent and water.
4. Oil or grease stains should rst be treated with a dry cleaning solvent followed
by a spray cleaner or detergent and water.
5. Do not use bleach.
You don’t need to take the seat out of the truck to put the seat cover on!
We just took it out because we couldn’t get the truck on our design table.

For assistance with installation, call us at 507.246.3545
q 1.1 - Pull the seat back cover down over the seat, making sure that the orange tag faces the door. Turn it 1/2 way
inside out before you put it on the seat, then just unroll it down the seat back.
q 1.2 - Push the aps between the seat back and the seat bottom.
q 1.3 - Pull the aps as tight as you can and fasten them to the back of the seat cover. The tighter you pull them, the
better the cover will look!
1 - Install Seat Back Cover

For assistance with installation, call us at 507.246.3545
2 - Install Seat Bottom Cover
q 2.1 - Put the cover over the seat bottom with the two long aps at the back.
q 2.3 - Run the strings down under the seat bottom and fasten with the orange StringLock. The tighter you pull the
strings, the better your seat cover will t!
q 2.4 - Push the two long aps between the seat back and bottom and run them under the seat bottom. Pull them as
tight as you can and fasten to the Velco strip at the front of the seat bottom cover.

For assistance with installation, call us at 507.246.3545
THE STRINGLOCK
Run one string through the channel on the
end of the StringLock.
Pull the string tight, pulling the StringLock
towards one edge of the seat. Press the
string into the clamp, locking it in place.
Run the second string through the
StringLock just like the other one.
Pull the loose end of the second string until
everthing is tight and lock it into place as
well.
1
3
2
4
Watch the video
ttcovers.com/stringlock