TigerTough E82201B User manual

It’s not rocket science,
but following these
instrucons will make
installing your seat covers
a lot easier.
We promise.
E82201B BUCKET

INSTALLATION GUIDE
E82201B EQUIPMENT BUCKET
Komatsu PC88MR-10 Seat Cover

For assistance with installation, call us at 507.246.3545
BILL OF MATERIALS
ITEMITEM QUANTITY
Driver Seat Back Cover 1
Driver Seat Bottom Cover 1
Headrest Cover 1
General care instructions:
1. In most cases dirt, debris, spills and pet hair can be removed by wiping with a
damp cloth.
2. Seat covers can be removed and machine washed on low temperature setting
using mild detergent.
Drip dry or machine tumble dry on a no heat cycle.
Straps should be coiled and secured with rubber bands for machine washing
and drying.
3. Soil may be removed with spray cleaner or detergent and water.
4. Oil or grease stains should rst be treated with a dry cleaning solvent followed
by a spray cleaner or detergent and water.
5. Do not use bleach.

For assistance with installation, call us at 507.246.3545
Your new seat covers are covered by a
two-year, unconditional, no B.S. warranty.
That means that if you manage to abuse
them to a point that they can’t perform like
they’re supposed to within two years of when
you bought them, we’ll make it right.
Depending on what is more practical, we’ll
either repair or replace the damaged cover.
Basically, you break it, we buy it.
Seriously.

For assistance with installation, call us at 507.246.3545
Install Seat Bottom Cover
Raise headrest
to the highest
position.
1
2
3
4
Undo all velcro
on the cover.
Slide the cover
over the seat
back.
Pull cover all of
the way down the
seat back. Undo
velcro ap around
armrest.
Secure the three
velcro tabs under
the headrest.
Secure velcro
tabs under the
armrest.
Push velcro tabs
between the seat
back and bottom.
Pull aps tight
and secure to
the velcro at the
back.
5
6
7

For assistance with installation, call us at 507.246.3545
Seat Bottom & Headrest
Place the cover over the seat bottom.
Push the velcro tabs between the
seat back and seat bottom.
Make sure that the cover is not over
top of the seat adjustment bar at the
front of the seat.
Pull the aps that you pushed
between the back and the bottom
tight, and secure them to the velcro
behind the seat. The tighter you pull
them the better the cover will t.
Slide the headrest cover over the
headrest and fasten the velcro at the
bottom.
9
10
11
12