TigerTough 112122 User manual

INSTALLATION GUIDE
112122 NATIONAL HIGH BACK
STATIONARY, NO ARMREST

Your new seat covers are covered by a
two-year, unconditional, no B.S. warranty.
That means that if you manage to abuse
them to a point that they can’t perform like
they’re supposed to within two years of when
you bought them, we’ll make it right.
Depending on what is more practical, we’ll
either repair or replace the damaged cover.
Basically, you break it, we buy it.
Seriously.

CONTENTS IN PACKAGE
INSTALLATION INSTRUCTIONS
q 1 - Install Seat Back Cover.
q 1.1 Turn seat back cover 3/4 of the way inside out.
q 1.2 Pull cover over seat back, pulling ght against top of seat.
q 1.3 Connue pulling the cover over the seat back, unrolling it as you go.
q 1.4 Aach Velcro aps under arm rest. You may need to work the arm rest back and forth to get the seam
to meet up.
q 1.4.1 Push front ap of cover between seat back and seat boom.
q 1.4.2 Pull ap ght and fasten to Velcro on seat back.
q 2 - Install Seat Boom Cover.
q 2.1 Place seat boom cover over boom of seat.
q 2.2 Push ap on top of cover between seat back and seat boom.
q 2.3 Push front ap under seat boom. Flap must go over all seat brackets.
q 2.4 Push strings from side aps under the seat. Strings must go underneath brackets that aach seat back
to seat boom.
q 2.5 Tie strings behind seat.
q 2.5.1 Pull strings ght. Secure with StringLock.
q 2.6 Pull ap from front of seat cover ght and fasten to Velcro on back of seat boom.
Congratulaons! You are nished.
For Assistance Call Us At 507.246.3545
q 1 - Seat Back Cover
q 1 - Seat Boom Cover

For Assistance Call Us At 507.246.3545
1.2- Cover inside out and on 1.3- Pull cover over seat back
2.6 - Push ap over brackets
2.2 - Push ap through to back2.1 - Put cover on seat boom
1.6 - Fasten ap to back of seat1.5 - Push ap through to back
2.8.2 - Secure String With StringLock

THE STRINGLOCK
Run one string through the channel on the
end of the StringLock.
Pull the string tight, pulling the StringLock
towards one edge of the seat. Press the
string into the clamp, locking it in place.
Run the second string through the
StringLock just like the other one.
Pull the loose end of the second string until
everthing is tight and lock it into place as
well.
1
3
2
4
Watch the video
ttcovers.com/stringlock