TigerTough 55571 User manual

It’s not rocket science,
but following these
instrucons will make
installing your seat covers
a lot easier.
We promise.
55571
FORD MAVERICK
REAR BENCH NO ARMREST
PART:
FITMENT DETAILS:
PRODUCT:
PIECES: (1) BACK COVER
(1) BOTTOM COVER
(3) HEADREST COVERS

General care instructions:
1. In most cases dirt, debris, spills and pet hair can be removed by wiping with a
damp cloth.
2. Seat covers can be removed and machine washed on low temperature setting
using mild detergent.
Drip dry or machine tumble dry on a no heat cycle.
Straps should be coiled and secured with rubber bands for machine washing
and drying.
3. Soil may be removed with spray cleaner or detergent and water.
4. Oil or grease stains should rst be treated with a dry cleaning solvent followed
by a spray cleaner or detergent and water.
5. Do not use bleach.
Your new seat covers are covered by a
two-year, unconditional, no B.S. warranty.
That means that if you manage to abuse
them to a point that they can’t perform like
they’re supposed to within two years of when
you bought them, we’ll make it right.
Depending on what is more practical, we’ll
either repair or replace the damaged cover.
Basically, you break it, we buy it.
Seriously.

PAGE 1
Remove headrests by
pushing in plastic tab
on the base and lifting
upwards
Tip seat back forward
by pulling the release
strap
Push the seat back
cover between the
seat belt and the seat.
Make sure to pull the
release strap through
the slit in the cover
that’s there for it.
Press cover down
around the headrest
mounts to tuck the
edges under them and
give it a clean, nished
look
Push the aps in
between the seat back
and bottom.
Tip seat back forward to
pull the aps tight and
secure it to the velcro
behind the seat.
22
11
33
44
55
66
77
CALL US AT 507.246.3545. FOR INSTALLATION ASSISTANCE

PAGE 2
Fold the seat bottom up
and pull on the cover
with the aps on top.
Push the aps
between the seat back
and bottom.
Pull the aps tight and
secure to the velcro.
Repeat for the driver
side.
55
77
88
CALL US AT 507.246.3545. FOR INSTALLATION ASSISTANCE
Work the release straps
through the holes.
IMPORTANT: do this
beofre lowering the
seat again!
66

PAGE 3
Put headrests
back on. Put on
the cover with
the ap facing
the front.
Secure the ap to the
velcro on the inside
of the back of the
headrest cover.
1122
FINISHED!