Travis Industries Wilmington Face User manual

Small Flush Wood Wilmington Face
Installation Instructions 96300207
Page 1 of 4 17601808.docx — 9/23/13 © Travis Industries, Inc.
Compatibility
•Small Flush Wood Insert – Arched
Face Sizing
NOTE: The small flush wood insert may be installed with a face and no surround panel. The face is 30”
wide and 21.5” tall.
Packing List
•Wilmington Face
•Ashlip
•(2) ¼-20 x 1” Bolts
Attaching the Ashlip to the Face
1 Place the face a non-scratching surface (front side upwards). Take care to prevent damage to the
mounting brackets or the wiring from the rheostat. Before installing the ashlip, make sure the center
clip is slightly loose (when tightened, it will secure the center of the ashlip to the face).
2 Place the ashlip in position and secure using the two included bolts (7/16” wrench).
Make sure the center
clip is slightly loose.

Small Flush Wood Wilmington Face
Installation Instructions 96300207
Page 2 of 4 17601808.docx — 9/23/13 © Travis Industries, Inc.
3 Place the face upright. Position the center clip so it is snug against the ashlip. Tighten the two nuts
on back of the face to secure the center of the ashlip to the face (11/32” wrench).
Attaching the Face to the Insert
WARNING: Unplug or disable power to the appliance prior to attaching or removing the face.
1 Pull the air control and bypass out fully.
2 Unscrew the bypass rod from the bypass yoke (make sure to detach the handle and rod as one
piece). Unscrew the air control rod from the air control.

Small Flush Wood Wilmington Face
Installation Instructions 96300207
Page 3 of 4 17601808.docx — 9/23/13 © Travis Industries, Inc.
3 The power cord may be routed behind the surround panel or between the surround panel and face. If
routing between the surround panel and face, remove the knock-out along the bottom edge of the
face (knock-outs are provided on both sides – make sure to use the correct side). An additional
knock-out is provided for the optional GreenStart igniter (typically left side).
4 Place the face near the insert. Attach the two quick-connects from the rheostat to the two leads on
the insert (see illustration on the following page - wire orientation does not matter). When installing
the face, make sure to tuck excess wiring into the area to the side of the insert (behind the surround
panel, if applicable). If routing the power cord between the face and surround panel, make sure it
lines up correctly. All wiring must be kept away from any hot or moving components.
Power cord knock-out
(left or right side).
GreenStart igniter knock-out
(typically left side).

Small Flush Wood Wilmington Face
Installation Instructions 96300207
Page 4 of 4 17601808.docx — 9/23/13 © Travis Industries, Inc.
5 The face uses hooks to hang in place. Lift the face slightly and slide into place. Take care to prevent
damage to the wiring while installing. Re-attach the bypass and air control rod.
Make Sure the Face is Fully Engaged
Because the face hooks are concealed, it may be difficult to determine if the face is
fully engaged. When in place the face will slide behind the cast seal plate. See
the photo below.
















