Travis Industries 96400717 User manual

Large Flush Wood Insert Face Installation
Shadowbox Black 96400717, Shadowbox Bronze 96400718, Times Square 96400719
.cnI,seirtsudnIsivarT©51/81/6detnirP-786106712fo1egaP
Compatibility Packing List
Large Flush Wood Rect. Insert
NOTE: Do not build facing up to the faceplate (a
3/8” gap is required to allow for air to circulate).
Face (see below)
(2) Rod Extenders
Bypass Ring
Installation
1. Before installing the face, the insert must be in place with the flue and surround panel attached.
2. Pull the bypass forward then remove the bypass rod (you may need pliers - see “a” below).
3. Remove the air control rod and knob (you may need pliers – see “b” below).
4. Place the face near the insert. Connect the rheostat wires from the face to the rheostat wires on the
insert (orientation does not matter – see “c” below). Make sure the power cord is routed through the hole
in the surround panel.
c
a
b
Sizing
Height Width
958mm wide667mm high

Large Flush Wood Insert Face Installation
Shadowbox Black 96400717, Shadowbox Bronze 96400718, Times Square 96400719

Page 2 of 2 17601687 - Printed 6/18/15 © Travis Industries, Inc.
5. Attach the face to the insert (see “a” below).
WARNING: When installing the face, make sure all wiring is inserted into the cavity between the
insert and the fireplace. Failure to do so may lead to damaged wiring.
6. Attach the bypass ring to the bypass rod. Attach one rod extender to the back of the bypass rod. Then
thread this assembly into the yoke on the bypass plate (see “b” below).
NOTE: take care when installing the bypass rod. You do not want to push the yoke all the way in,
causing it to disengage from the bypass hole. If it does disengage, you will need to reach through the
bypass opening and insert the yoke through the bypass hole.
7. Attach the air control rod to the rod extender then attach it to the air control (see “c” below).

a
b
c