U-Line H-1069 User manual

PAGE 1 OF 3 0614 IH-1069
πH-1069
6" CRIMPER
HAND SEALER
1-800-295-5510
uline.com
SETUP
1. Attach the two metal clamp brackets (A) approximately
4⁄" apart to any straight-edge table with a depth 1⁄"
and height of up to 36". (See Figure 1)
2. Attach the silver link chain (B) to jaw bracket (C).
Holding the sealer jaws together, push the jaw
bracket pins up from the bottom of the sealer until
they snap over the top of the unit. Position the
bracket as close to the sealing jaws as possible.
(See Figure 2)
Rest the sealer on the clamp brackets. Attach the
other end of the chain to the “S” hook on the foot
pedal (D). (See Figure 3)
3. Position the foot pedal directly underneath the
sealer and pointed away from you, so the tip with
the “S” hook is pointing toward the sealer (or table).
Leave enough tension in the chain so that the tip of
the pedal lifts 2-3" from the floor. (See Figure 3)
A
Figure 1
C
C
B
Figure 2
D
Figure 3

PAGE 2 OF 3 0614 IH-1069
NOTE: The sealer will take APPROXIMATELY 10 TO
15 MINUTES TO WARM UP.
1. Turn the unit on by plugging it in and adjusting the
temperature dial. See Settings Chart (page 3) to
determine optimal temperature. (See Figure 4)
2. Once the unit is warmed up, insert bag into the
mouth of the sealer and apply pressure to the foot
pedal to seal the bag. (See Figure 5 and 6)
3. Take pressure off
the foot pedal to
release the sealing
jaw and remove the
bag. (See Figure 7)
4. If not using the foot pedal, insert bag into the sealer
and squeeze the handle of the unit together. Hold to
seal the bag. (See Figure 8)
5. Release the handle and remove the sealed bag.
(See Figure 9)
6. Allow the sealer to cool down for 15 minutes
before storing.
OPERATION
MAX
MIN
OFF
8
7
65
4
3
2
1
ON
Figure 4
Figure 8
Figure 9
Figure 5
Figure 7
Figure 6

PAGE 3 OF 3 0614 IH-1069
NOTE: The H-1069 6" Crimper Hand Sealer is
designed to seal cellophane, polypropylene,
and foil bags only.
CAUTION! DO NOT USE with polyethylene,
fabric, burlap, Tyvek® or bags made of
other materials.
OPERATING ISSUE RECOMMENDATIONS
Sealer is not heating up. Sealer must be warmed up for 15 minutes prior to use.
Sealer is melting the bags. Adjust dial to a lower setting to reduce the heat.
See above for recommended settings.
Sealer is burning the bags. The bag is made of polyethylene, fabric or another material which
is not compatible with this sealer.
Sealer is not sealing. Adjust dial to a higher setting to increase the heat.
See above for recommended settings.
TROUBLESHOOTING
MIL BAG TYPE DIAL SETTINGS
1.2 Cellophane 3
1.5 Polypropylene 3
3Polypropylene Between 3 and 4
2.2 Metallized 4
5Foil 4
RECOMMENDED SETTINGS
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com