PAGE 2 OF 2 0421 IH-6581
ASSEMBLY
NOTE: Check that all parts are included in
packaging. Names are molded into all parts.
Select a site with level ground and good
drainage. The door and roof function best when
the shed is level.
1. Slide the two back pieces together. (See Figure 1)
2. Bend the two sides to form a 90° angle with the back.
(See Figure 2)
3. With the molded word "floor" facing up, slide the floor
into place between the sides. You may need a rubber
mallet to tap the floor into place. (See Figure 3)
4. To install left door, align hole in top of door with pin on
the side wall. Rotate door and snap pin on bottom of
door into hole in floor. (See Figure 4)
5. Repeat with other side.
6. Slip roof support rod into guide formed in right panel.
Slide the back of roof onto the pivot point on back.
(See Figure 5)
7. A shelf can be easily added, if desired, by using
standard 3/4" thick lumber cut to be fit into the
molded-in shelf brackets. (See Figure 6)
NOTE: Insert the shelf with the clip corners facing
the back of the shed. Insert the left end of the
shelf first, then push the right end into place.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
CARE INSTRUCTIONS
• Periodically inspect the shed to ensure proper
assembly is maintained and site remains level.
• Clean shed using garden hose or wash with a mild
detergent and water.
• The shed can be secured to any immovable object
by drilling through four molded-in recessed areas in
the back panel.
• The shed can also be secured by drilling through
four floor locations and inserting stakes into the
ground.
CAUTION! Do not clean with a stiff or abrasive
cleaner. Wear safety glasses and follow the
manufacturer's instructions when using power
tools. Do not store hot yard equipment, grills or
other hot materials in the shed.
-800-295-551
