Ubiquiti BulletAC-IP67 User manual

Dual-Band airMAX®AC
Radio with Dedicated
Wi-Fi Management
Model: BulletAC-IP67

Introduction
Thank you for purchasing the Ubiquiti Networks® airMAX®
Bullet™AC IP67. This Quick Start Guide is designed to guide
you through installation and includes the warranty terms.
Package Contents
Bullet AC IP67 N-Type Right
Angle Adapter

Installation Requirements
• Shielded Category 5 (or above) cabling with drain wire
should be used for all outdoor wired Ethernet connections
and should be grounded through the AC ground of the PoE.
We recommend that you protect your networks from
harmful outdoor environments and destructive ESD events
with industrial-grade, shielded Ethernet cable from Ubiquiti
Networks. For more details, visit
www.ubnt.com/toughcable
• Surge protection should be used for all outdoor installations.
We recommend that you use two Ethernet Surge Protectors,
model ETH-SP, one near the Bullet and the other at the entry
point to the building. The ETH-SP will absorb power surges
and safely discharge them into the ground.
To LAN
To Antenna
ETH-SP
ETH-SP
ES-8-150W
BulletAC-IP67

Hardware Overview
N-Type
Connector
Bullet AC
Radio
Rubber Washer
Cable Gland Body
Compression Nut
Ethernet Port
Compression Seal

Hardware Installation
1. Unscrew the Cable Gland Body and detach it from the
Bullet AC Radio.
2. Unscrew the Compression Nut and remove the Compression
Seal from the Cable Gland Body.

3. Slide the Compression Nut over the Ethernet cable with
the threaded end facing the RJ-45 connector. Slip the
Compression Seal around the cable.
4. Feed the Ethernet cable through the Cable Gland Body and
seat the Compression Seal into the Cable Gland Body.
5. Connect the Ethernet cable to the port located on the
bottom of the Bullet AC Radio.

6. Securely screw the Cable Gland Body into the Bullet AC
Radio so that the Rubber Washer seals the bottom of
theradio.
7. Tightly screw on the Compression Nut. Ensure the
Compression Seal is securely compressed and tightly sealed
around the cable.

8. Connect the Bullet to the N-Type connector of the antenna.
Note: The Bullet should be mounted vertically to
reduce stress on the N-Type Connector. The N-Type
Right Angle Adapter may be used as needed.

Accessing airOS via Wi-Fi
Verify connectivity in the airOS® Configuration Interface.
There are two methods, the UNMS™App and Web Portal. Both
are available for 15minutes immediately after you power on
the device. If necessary, you can power cycle the Bullet AC to
re-enable its Wi-Fi.
Proceed to the appropriate instructions:
UNMS App
1. Download the UNMSapp from the AppStore® (iOS) or
Google Play™(Android).
2. Connect your device’s Wi-Fi to the Bullet AC SSID named:
BulletAC-IP67:<MAC Address>
Note: Ensure that DHCP is enabled on your
Wi‑Fiadapter.
3. Launch the app.
4. Tap the Bullet AC on the Connections screen.
Bullet AC IP67
BulletAC-IP67
192.168.172.1
:F08FC2552018

5. Tap Connect on the Login screen.
Bullet AC IP67
BulletAC-IP67: F08FC2552018
192.168.172.1
6. Select your Country and tap Done.
United Kingdom
Argentina
Armenia
Aruba
Australia
Austria
Azerbaijan
Bahrain
Barbados
Belarus
Note: For the Country setting, U.S. product versions are
restricted to a choice of Canada, Puerto Rico, or the U.S.
to ensure compliance with FCC/IC regulations.