Ublox EVK-W262U User manual

Quick Start EVK-W262U
Download the EVK-W262U software
(and documentation) from www.u-blox.
com/evk-downloads. Click on “Resources
to download” and install the software.
See notes on back of the card.
1. Insert the EVK-W262U kit into a
USB port on your computer.
2. Verify that the FTDI driver is
installed successfully. If necessary,
download the drivers for the FT231X
chipset from www.ftdichip.com.
3. Download the latest firmware to the
ODIN-W2 module using s-center
evaluation software.
1. Setup
UBX-15016340 - R02
RGB
LED
(LD5)
USB
Connector
(J2)
Reset
button
(SW1)
Restore
button
(SW2)
UART
indication
LEDs
(LD3, LD4,
LD1, LD2)
ODIN-W2
multiradio
module
(M1)

To download the EVK-W262U software
package and run the installation:
• An Internet connection is required.
Supported Windows operating
systems: Vista, 7 and 8.
• Download s-center software.
• Run the s-center exe file and follow
the installer instructions.
• When the installation is complete,
you will find the s-center menu
under the Windows Start button,
All Programs > u-blox
• In the s-center menu, you will find
the s-center application, user guide
and uninstall options.
2. Installation
To restore to factory default settings:
Toggle the Reset button (SW1) while
holding the Restore button (SW2) until
the RGB LED (LD5)turns orange and
you are prompted with the welcome
message “+STARTUP”. This takes
approximately 10 seconds.
3. Troubleshooting
For more information regarding the
EVK-W262U, contact your nearest
u-blox support:
www.u-blox.com/contact-support
4. More information
UBX-15016340 - R02 Copyright © 2016, u-blox AG