URBAN OUTFITTERS TABITHA User manual

TABITHA DESK
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted.
Page 1 of 3
TOOLS REQUIRED BUT NOT INCLUDED:
Phillips head screwdriver
Do not throw away packing materials and carton until after
assembly. Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight. Do not place over heat or Air conditioning vents.
Adjust levelers so that the furniture sits flat on uneven floors.
Blot spills do not rub, with a clean white cloth. Do not use harsh chemicals. Before
cleaning any part test a small spot in a hidden area. You may need to re-tighten all
bolts after initial use.
PARTS INCLUDED
(C) Hex key
1x
(D) Bolt
[1/4” x 7/8”] x12
(E) Spring washer
[1/4"] x12
(F) Flat washer
[1/4"] x12
TIP KIT
(G) Nylon strip (H) Bracket
x2
(I) Screw
[M3 x 32mm] x2
(J) Screw
[M3 x 19mm] x2

TABITHA DESK
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 2 of 3
STEP 1
With help lay the Desk (A) over onto a clean smooth surface such as carpet or cardboard. Align the Legs (B) as shown and insert
Flat Washer (F), Spring washer (E), and Bolt (D). Tighten with supplied Hex Key (C). Do not over tighten.
Carefully stand the cabinet upright without leaning it on the legs as this can cause damage.
STEP 2
Unscrew the Drawer pull installed inside the Drawer with a Philips Head Screwdriver (not included). Attach the Drawer pull to
the Drawer front and insert the original Machine Screw to secure with a Phillips Head Screwdriver. Do not over tighten.

TABITHA DESK
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 3 of 3
STEP 3
Turn the adjustable feet so the Desk sits flat on
the ground.
STEP 4
Align the Anti Tip Brackets (H) to the Top back of the Desk. Insert Screws (I)
and tighten completely. Do not over tighten.
STEP 5
Contact your local hardware store to purchase the correct anchors for your wall-type.
Align the brackets to the wall and make sure they line up with the brackets on the back of the case from step 1. Screw the
brackets to the wall using the correct anchors.
Slide the case to the wall. Leaving a little bit of room between the case and the wall.
Feed the Nylon Strap through both brackets and pull tight.