VistaLab Ovation M Use and care manual

When to replace:
VistaLab Technologies suggests that the
pipette plunger button be replace when
the following symptoms are present:
• The button or clear lens has been
cracke or amage
• The button has fallen off completely
Pl nger B tton Kit incl des:
• Replacement Plunger Button
• Instructions
Refer to the chart below to etermine
the appropriate kit.
Description Catalog No.
Plunger Button Kit for Ovation M models dispensing 0.2-2µL 9070-4014
Plunger Button Kit for Ovation M models dispensing 1-10µL 9070-4015
Plunger Button Kit for Ovation M models dispensing 2-20µL 9070-4016
Plunger Button Kit for Ovation M models dispensing 10-100µL 9070-4017
Plunger Button Kit for Ovation M models dispensing 20-200µL 9070-4018
Plunger Button Kit for Ovation M models dispensing 100-1000µL 9070-4019
*
Pl nger B tton Replacement
Ovation M

L070-0009-001 Rev A
VistaLab Technologies, Inc.
2 Geneva Roa
Brewster, NY 10509 USA
[phone] • [phone]
Replacing a Pl nger B tton:
1. Set the pipette to its maximum volume
and pla e on a flat surfa e in its verti al
orientation.
2. While holding the pipette body, remove
the plunger button by pulling dire tly
upwards on the button until the button is
free from the pipette (see Figure 1).
(Note: May take onsiderable for e)
3. Atta h the new plunger button by aligning
its enter hole with the plunger shaft
making sure the hexagonal features
appropriately align. Press down firmly until
a li k is heard (see Figure 2 and 3).
4. Ensure plunger button is orre tly
installed by twisting and pulling upward
lightly.
5. Verify pipette performan e
Figure 1: Button Removal
Figure 2: Plunger Button Alignment
Figure 3: Plunger Button Reattachment