VistaLab Ovation M Use and care manual

When o replace:
VistaLab echnologies suggests that the
Ovation pipette’s Ergo Hook and/or op
Cover be replaced if any of the following
conditions are present:
• he hook is either cracked or
damaged
• he hook will not rotate or will not
hold its designated position during
routine use
• he top cover is either cracked or
damaged
Hook & Top Cover Ki includes:
• Replacement op Cover
• Replacement Hook
• Replacement Plunger Button
• orx Key ( 6 X 50)
• Instructions
Refer to the chart below to determine
the appropriate kit.
Descrip ion Ca alog No.
Hook & Top Cover Kit for Ovation M models dispensing 0.2-2µL 9070-4008
Hook & Top Cover Kit for Ovation M models dispensing 1-10µL 9070-4009
Hook & Top Cover Kit for Ovation M models dispensing 2-20µL 9070-4010
Hook & Top Cover Kit for Ovation M models dispensing 10-100µL 9070-4011
Hook & Top Cover Kit for Ovation M models dispensing 20-200µL 9070-4012
Hook & Top Cover Kit for Ovation M models dispensing 100-1000µL 9070-4013
Hook & Top Cover Replacemen
Ovation M

Replacing a Hook and Top Cover:
1. Set the pipette to its maximum volume
and place on a flat surface in its vertical
orientation.
2. While holding the pipette body, remove
the plunger button by pulling directly
upwards on the button until the button
is free from the pipette (see Figure 1).
(Note: May take considerable force)
3. sing the provided Torx Key, remove all
three top cover screws (see Figure 2).
4. Remove both the top cover and hook
by pulling both directly upwards while
holding the pipette body (see Figure 3).
5. Attach the new hook to the new top
cover by first pinching the back edge of
the hook ring against the top cover shaft
hole (see Figure 4).
6. Pinch the rest of the hook ring into place
by sliding your fingers away from the
back edge until a click is heard
(see Figure 5).
Figu e 1: Button emoval
Figu e 2: Top cove sc ews
Figu e 3: Hook and top cove Removal

7. With the hook and top cover
connected, fit the top cover over the
threaded shaft and ejector button until
it lightly snaps in place.
8. sing the Torx Key, secure the top
cover with the three top cover screws
until snug.
9. Attach the new plunger button by
aligning its center hole with the
threaded shaft making sure the
hexagonal features appropriately align.
Press down firmly until a click is heard
(see to Figure 6 and 7).
10. Ensure plunger button is correctly
installed by twisting and pulling
upward lightly.
11. Verify pipette performance.
Figu e 4: Side view of initial alignment
Figu e 5: Hook and top cove Connection
Figu e 6: Plunge button alignment Figu e 7: Plunge button eattachment

L070-0008-001 Rev A
Vis aLab Technologies, Inc.
2 Geneva Road
Brewster, NY 10509 USA
[phone] • [phone]