Vivo MOUNT-E-WM075 User manual

Electric Swing TV Wall Mount
Scan the QR code with your mobile device or follow the link
for helpful videos and specications related to this product.
Instruction Manual
https://vivo-us.com/products/mount-e-wm075
SKU: MOUNT-E-WM075
[email protected]om www.vivo-us.com 309-278-5303
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

2
PACKAGE CONTENTS
110lbs
(50kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
WARNING!
A (x1)
Mount
B(x1)
Template
C(x2)
VESA Bracket
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualied technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specied in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED
D(x1)
Top Cover
E (x1)
Bottom Cover
T-B (x1)
Level
G (x1)
Power Cord
H(x1)
Remote
I(x5)
Strap
M-A (x4)
M5x14 Screw
M-B (x4)
M6x14 Screw
M-C (x4)
M6x30 Screw
M-D (x4)
M8x30 Screw
M-E (x4)
M8x50 Screw
M-F (x4)
M5-M8 Washer
M-G (x8)
M8x5 Spacer
M-H (x8)
M8x15 Spacer
W-A (x6)
ST6.3x55 Screw
W-B (x6)
Concrete Anchor
CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO
MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us.
com, email at [email protected], or call us at 309-278-5303.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
W-C (x4)
M6 Washer
T-A (x1)
4mm Allen
Wrench

3
ASSEMBLY STEPS
STEP 1
Temporarily plug Power Cord (G) into Mount (A) and then into an AC outlet. While holding mounting
arm, use Remote (H) to unfold the mounting plate until it is 90 degrees to the arm. Then remove the
Power Cord (G).
TOOLS NEEDED
3/8” Drill Bit Pencil
Phillips
Screwdriver Drill
Stud Finder
Tape Measure 3/16” Drill Bit
Mounting
Arm
Mounting
Plate
A
Using a Phillips screwdriver, remove the mounting
arm screws.
L
Adjust length of mounting arm based on the size of your TV.
Reinstall the mounting arm screws.
TV
L
2+13”
X= L
2+33cm
X=
OR
G

4
STEP 2
OPTION A: Wood Stud Installation
Locate the stud in the wall where you will
mount the assembly. Use of a studnder is
recommended. Place Template (B) over the stud
and use Level (T-B) to align, and mark drilling
locations. Remove Template (B), drill 2.2” (55mm)
deep holes using a 3/16” (4.5mm) drill bit. Insert
one ST6.3x55 Screws (W-A) into the top-middle
hole, leaving 7mm of threads exposed. Slide
Mount (A) onto the screw and secure to the wall
using ST6.3x55 Screws (W-A) and M6 Washers
(W-C).
OPTION B: Concrete/Brick Installation
Place Template (B) on the wall in the desired
location and use Level (T-B) to align, and mark
drilling locations. Remove Template (B), drill 2.4”
(60mm) deep holes using a 3/8” (10mm) drill bit.
Insert Concrete Anchors (W-B) into predrilled holes.
Insert one ST6.3x55 Screws (W-A) into the top
middle anchor, leaving 7mm of threads exposed.
Slide Mount (A) onto the screw and secure to the
wall using ST6.3x55 Screws (W-A) and M6 Washers
(W-C).
T-B
T-B
Swing Le (Clockwise) Swing Le (Clockwise)
Swing Right (Counter Clockwise) Swing Right (Counter Clockwise)
T-B
T-B

5
STEP 3
Assemble Top Cover (D) and Bottom Cover (E) to Mount (A).
STEP 4
Using a Phillips screwdriver, loosen the safety screws on the back of VESA Brackets (C).
A
C

6
STEP 6
Hang VESA Brackets (C) over Mount (A). Tighten safety screws on VESA Brackets (C) to secure in place.
STEP 5
Attach the VESA Brackets (C) to the back of the TV using Screws (M-A through M-E), M5-M8 Washers
(M-F) and Spacers (M-G, M-H).
C
C
A

7
STEP 8
Plug Power Cord (G) into Mount (A) and then into an AC outlet. Use Remote (H) to operate.
CAUTION: To avoid injury, do not place hand in the arm while operating.
STEP 7
Level the TV by adjusting the leveling screws ontop of VESA Brackets (C) using 4mm Allen
Wrench (T-A) and Level (T-B). Use Straps (I) to organize cables.
T-A
C
I
T-B
A

LAST UPDATED: 12/1/2021
REV1.1
Open Monday - Friday 7:00am - 7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times. If any
parts are received damaged or defective, please contact us. We are happy to replace parts to
ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
[email protected] AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
AVG. RESOLUTION TIME (within oice hrs): < 15 M
www.vivo-us.com
Chat live with an agent!
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
309-278-5303