
17
16
Assembling manual
Fastening of coverage
Install side parts of the butt end as
shown in Fig.16. Holding a piece of cover
surface in place, fasten it with screws
and washers on parts 8 (Fig. 22). And
on angles with the use of self-tapping
screws with washers. Holes for screws
should be drilled with 4 mm bore from
inside the greenhouse through ready-
made holes in frame parts. Install pieces
of “half-rounded ridge” by fastening it
to angles with self-tapping screws with
washers. Cut off any overlapping parts on
the sides.
3.
Fig.16
protective layer
element 9-1, 9-2
end coverage
Cutting is better done with an electrical fret saw, or with a jigsaw with
small sawteeth.
The polycarbonate should be installed with the strongly dened outer
side (towards the sun), having a protective layer (always make sure when
purchasing or before installation). The protective layer is usually on the
side with inscriptions on the packaging lm. On the other side of the sheet
the lm is clear. After drawing the planning lines on the sheet but before
cutting it, mark the protective side of every piece of polycarbonate: after
removing the packaging lm, both sides of the sheet look very similar. The
packaging lm should be removed from both sides right before fastening
the cover surface to the frame.
In Fig.15 is a diagram of cuttingt for installation of greenhouses on the
Foundation. If the greenhouse is installed on the ground, the lower part
of the sidewalls of the end, it is recommended to extend 200 mm for the
corresponding deepening of the polycarbonate in the ground. this depth
of coating along the perimeter of the greenhouse creates a barrier to the
penetration of the greenhouse the roots of weeds.
To cover greenhouses need:
for “Dachnaya-Dvushka” - 2 sheets; for “Dachnaya-Dvushka”+insert - 3 sheets;
“Dachnaya-Dvushka”+2 inserts - 4 sheets of polycarbonate with a thickness of
4(6)mm size 2.1 x 6 m.
2. Cut a piece of polycarbonate (the cutting line Fig.15). Put the piece of cover on the
end, strictly combining the outer edge of the coating elements 9-1, 9-2 (Fig. 16)
and draw the elements 1, 4n and 4вк. cut out pieces of the coating to the seam
allowance. Then put the assembled door and window to the coating sheet with the
addition of one lateral edge opposite the hinges of the hinge is 15 mm. pieces of the
coating, located above the window, cut at the installation site.
1.
Assembling manual
Left side of
the end
Left side
of the
end
Door
Door
Window
Window
Ridged
panel
Right side
of the end
Right side
of the end
CUTTING POLYCARBONATE SHEET PERFORM STRICTLY IN ACCORDANCE WITH THE
FIG.15
Polycarbonate sheet size 2100 x 6000 mm
2420 (installation on the ground)
600 600
200
800
Cut line
allowance
for penetration Into
the ground
allowence
for penetration into
the ground
threshold line
Plan of cutting cellular
polycarbonate with the
installation on the Foundation.
when installed on the ground
side extend.
Fig. 15
allowance for
penetration into the
ground
allowance for
penetration into the
ground
threshold line
2220 (installation on the foundation)