WATSON SEVEN DESK User manual

3-LEG DESK ASSEMBLY INSTRUCTIONS
SEVEN DESK
V.2.0 4/16 INS-SN3LEGTABLE

2 Bahn 3 Leg Table Assembly | INS-BN3LEGTABLE
3-LEG TABLE BASIC COMPONENTS
Legs
Feet
Support Rails
Control Box
Power Cable
Motor Cable
Alligator Clips
Inset
Switch
Undermount Wellness
Worksurface
FASTENERS TOOLS
#10x¾” Pan Head Wood
Screw (127000)
M6-1x12mm Nylock Nut
(888152)
#8x⅝” Truss Head
Panhead Screw (122800)
M6-1x40mm Phillips Pan
Head Machine Screw
(125293)
#2 Phillips
5/32” (or 4mm) Hex Tip
M6-1x12mm Button Head
Socket Cap Screw, Black
(125290)
¼-20x⅜” Phillips Pan
Head Machine Screw
(126665)

3 Seven 3-Leg Desk Assembly | INS-SN3LEGTABLE
Switch
AAssemble on a clean blanket or carpet.
BPush switch into pocket on the top side of the
surface.
CLay the worksurface face side down.
Two-Piece Worksurfaces
AJoin the two halves with Tite Joint fasteners.
BSecure the support channel with ¼-20x⅜”
Phillips Pan Head Machine Screw (126665 x8).
1.
2.
B
B
A
A
A
A
C

4 Seven 3-Leg Desk Assembly | INS-SN3LEGTABLE
Legs + Support Rail + Feet
APlace legs into support rails.
BAttach the support rail to the legs. then
attach each foot to the legs with M6-1x12mm
button head screws (x36).
Control Box + Wires
AAttach the motor cables and power cable to control box.
BFeed the power cable through the rail cutout.
CSecure the power cable to the control box. Loop power cable
into the small arcing groove and press in. This provides strain relief
for the power cord so it does not come disengaged during use.
Place the control box on the Rail in between the access cutouts.
DSecure control box in place with M6-1x40mm Phillips Pan Head
Machine Screw (125293) and M6-1x12mm Nylock Nut (888152)
Note — Route cables across
the front of the corner leg
and through the rail cutouts.
Underside Shown
3.
4.
B
B
B
A
A
A
A
C
C
C

5 Seven 3-Leg Desk Assembly | INS-SN3LEGTABLE
Connect Switch
APosition the worksurface on or near the leg
frame and connect the switch through the rail
opening.
BAlign the worksurface and secure with ¼-20x⅜”
Phillips Pan Head Machine Screw (126665 x18).
Test + Level
APlug power into 110V AC receptacle
and depress the down arrow to
initialize desk. The desk will travel
down a fraction of an inch then stop.
The desk is now ready to travel up and
down using the switch.
BPosition the desk, maintaining a
minimum 1” gap per ANSI/BIFMA safety
standards.
CAdjust leveling glides to ensure a
stable sit-stand performance.
DAttach Wire Managers. Use #8x⅝”
Truss Head Panhead Screw to secure
wire clips as needed.
Note — Clear all cables from the rail edge to
prevent pinch when securing the worksurface.
Note — Two people may be required to install
large surfaces.
5.
6.
B
B
A
A
C
C
D

6 Seven 3-Leg Desk Assembly | INS-SN3LEGTABLE
Notes