WATSON Watson Pin & Tak Deskmount Acrylic Screen User manual

V.1.00 06/2020 360.394.1300 watsonfurniture.com
ASSEMBLY
Watson Pin & Tak Deskmount Acrylic Screen

2 ACRYLIC DESKMOUNT SCREEN ASSEMBLY INSTRUCTIONS
Acrylic Deskmount Screen Basic Components
Medallions
Side Screen Back Screen
Brackets

Hardware
Tools
Phillips Drill/Driver Bit 2mm Hex Drill/Driver
Bit
3mm Hex Drill/Driver
Bit
Additional tools such as a 90 Degree Bit and an 18” Extension are helpful for some steps
*No torque or ball bits should be used
Electric Drill
¼-20 Lock Nut,
Zinc (090770)
Square Drive Thread Cutting
Screw #8x1 3/4” (0000238)
5/18-18x1”Clamping
Screw (0000229)

4 ACRYLIC DESKMOUNT SCREEN ASSEMBLY INSTRUCTIONS
↑ UP ↑ ↑ UP ↑
Back ScreenSide Screen
Position Medallions
Press Medallion plates into holes in acrylic until flush. Consult
visual to determine orientation for Desk and Side Screen.
NOTE: Medallion orientation depends on Screen type
Side Screen Shown
Side Screen Shown
Secure Brackets
Position mountion brackets onto the studs sticking through the
board and secure into place with nylon-lock nuts (090770).
¼-20 Lock Nut,
Zinc (090770)
1.
2.

5 ACRYLIC DESKMOUNT SCREEN ASSEMBLY INSTRUCTIONS
Insert Clamping Screw
For 90 edges, the clamping screw (0000229) can be
attached by screwing into the threaded hole on the
back internal of the bracket. The screw should have
atleast 3/4” clearance from top of bracket.
Attaching to Desk
Slide screen onto desk until bracket is flush with edge.
If a 90 Edge, tighten clamping screw upp against
underside of desk. If a knife edge, screw wood screws
(0000238) through front two holes into top.
Square Drive Thread Cutting
Screw #8x1 3/4” (0000238)
Side Screen + Knife Edge
Back Screen + Knife Edge
Side Screen + 90 Edge
Back Screen + 90 Edge
5/18-18x1”Clamping
Screw (0000229)
3.
4.