WATSON SEVEN User manual

2-LEG TABLE ASSEMBLY INSTRUCTIONS
SEVEN ELECTRIC
V.2.0 4/16 INS-SN2LEG-ELEC

26246 Twelve Trees Lane NW, Poulsbo, Washington 98370
800.426.1202 watsonfurniture.com [email protected]
2-LEG TABLE COMPONENTS
Legs
Feet
Support Rails
Control Box
Power Cable
Motor Cable
Alligator Clips
Inset
Switch
Undermount Wellness
Worksurface
FASTENERS TOOLS
#10x¾” Pan Head Wood
Screw (127000)
M6-1x12mm Nylock Nut
(888152)
#8x⅝” Truss Head
Panhead Screw (122800)
M6-1x40mm Phillips Pan
Head Machine Screw
(125293)
#2 Phillips
5/32” (or 4mm) Hex Tip
M6-1x12mm Button Head
Socket Cap Screw, Black
(125290)
¼-20x⅜” Phillips Pan
Head Machine Screw
(126665)

3 Seven 2-Leg Table Assembly | INS-SN2LEG-ELEC
Switch
AAssemble on a clean blanket or carpet.
BPush switch into pocket on the top side of
the surface.
CLay the worksurface face side down.
Legs + Support Rail + Feet
APlace Legs through Support Rail
BAttach the support rail to the legs. then attach
each foot to the legs with M6-1x12mm button head
screws (x16).
1.
2.
B
A
C

4 Seven 2-Leg Table Assembly | INS-SN2LEG-ELEC
Control Box + Wires
AFeed the power cable through the rail notch.
BSecure the power cable to the control box. Loop
power cable into the small arcing groove and press in.
This provides strain relief for the power cord so it does
not come disengaged during use. Place the control box
on the Rail in between the access cutouts.
CSecure control box in place with
M6-1x40mm Phillips Pan Head Machine
Screw (125293) and M6-1x12mm Nylock
Nut (888152)
DPlug cords
Connect Switch
AFeed the switch through the rail hole and
connect it to the control box.
BRotate the leg frame over the worksurface
brass inserts.
Underside Shown
3.
4.
B
B
B
A
A
C
C
D
D
D

5 Seven 2-Leg Table Assembly | INS-SN2LEG-ELEC
Attach Worksurface
AAlign the leg frame and push in
any stray cables.
BSecure the surface with
¼-20x⅜” Phillips Pan Head
Machine Screws (x8)
CAttach the wire clips with
#8x⅝” Truss Head Panhead
Screw (122800).
DSecure switch wire with
adhesive pads.
Test + Level
APlug power into 110V AC receptacle and depress
the down arrow to initialize desk. The desk will
travel down a fraction of an inch then stop. The
desk is now ready to travel up and down using the
switch.
BPlace the desk in the workstation, maintaining a
minimum 1” gap per ANSI/BIFMA safety standards
CAdjust leveling glides to ensure a stable sit-stand
performance
5.
6.
B
B
B
B
A
A
C
C

6 Seven 2-Leg Table Assembly | INS-SN2LEG-ELEC
Notes