WATSON Tonic User manual

Tonic Inno Table Assembly Instructions
Pg. 1 of 2 INS-TNC TWTRC
26246 Twelve Trees Lane NW, Poulsbo, WA 98370 | 800.426.1202 | www.watsonfurniture.com
Tools Required
Cordless drill, magnetic insert-bit holder, 8” or longer driver extension, #2 insert or Pozidriv bit
Step 1 –Position top components
Place the rotating top assembly (A) top-side down on a flat floor. Place the outer table top ring (B), top-side down, over the
rotating top assembly. Rotate the sub top so that the groups of 5 pilot holes are roughly aligned with the groups of 3 pilot
holes in the outer table top ring.
NOTE: Be sure the floor is cleaned of any debris that might scratch the table top surfaces.
Figure 1
ITEM NO.
COMPONENT
QTY
A
ROTATING TOP ASSEMBLY
1
B
OUTER TABLE TOP RING
1
C
LEG
4
D
#10 x 1” CROSS DRIVE, PAN HEAD SCREWS
32
A
B

Tonic Inno Table Assembly Instructions
Pg. 2 of 2 INS-TNC TWTRC
26246 Twelve Trees Lane NW, Poulsbo, WA 98370 | 800.426.1202 | www.watsonfurniture.com
Step 2 –Attach legs
Place a leg onto the tops so that the holes in the bracket align with those in the rotating top assembly. Drive five screws
through the holes in the bracket which surround the leg into the sub top. A driver extension will be required to reach the screws
nearest the edge of the sub top. Repeat this for the remaining three legs.
Rotate the legs and sub top, if necessary, so that the outer three holes in each of the leg brackets are aligned with the holes in
the outer top ring. Drive three screws through the holes in the brackets and into the outer top ring.
Turn the table assembly upright.
Figure 2
Operating, maintenance, and installation instructions are available at https://watsonfg.box.com/installation
D
C