WATSON Bahn User manual

LOCKER ASSEMBLY INSTRUCTIONS
BAHN
V.1.0 10/15 INS-BNLOCKER

26246 Twelve Trees Lane NW, Poulsbo, Washington 98370
800.426.1202 watsonfurniture.com [email protected]
LOCKER COMPONENTS
FASTENERS
TOOL TIPS
¼-20x1” FM Bolt (490710)
#2 Phillips
3/16 Drill Bit
5/16 Drill Bit
¼-20 Barrel Nut (490713) #8-¼x1¼” Phillips Pan Head
Wood Screw (0000163)
#10-¾” Phillips Pan Head
Wood Screw (122875)
One Door Locker Two Door Locker Three Door Locker Four Door Locker
Eight Door Cubby
Two Door Cubby Four Door Cubby Six Door Cubby
Anti-Tip Kit

3 Bahn Locker Assembly | INS-BNLOCKER
Place + Level
Move the lockers into position and level (maximum
extension is 2”).
Side to Side Ganging
ADrill 5/16” holes through the side walls at 7/64
pilot locations. Only partially drill through the side to
prevent chipping.
BConnect the units with ¼-20x1”FM bolts (x4) and
¼-20 Barrel Nuts (x4).
1.
2.

4 Bahn Locker Assembly | INS-BNLOCKER
Secure to Workbench
Anchor the Locker to the Raceway using #10 x ¾
screws (x4).
Secure to Freestanding Raceway
ADrill 2 each 3/16” clearance holes through the
Raceway End Panel.
BSecure the Locker to the Raceway with #8 x 1¼”
screws (x2).
3.
4.

5 Bahn Locker Assembly | INS-BNLOCKER
Secure to Wall + Anti-Tip
AMark and attach D-rings to the wall and the
cabinet.
BSlide the cabinet toward the wall leaving enough
room to attach the strap to the D-rings.
CAttach the strap and slide the cabinet as close to
the wall as it will go.
Note — Reference INS50008.
5.