WB Mfg Einstein Station User manual

1
wibenchmfg.com 507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identier Key) Any parts damaged during shipment must be
reported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Step 1:
• Attach (2) angle brackets to the inner side of the left leg
aligning them with the pre-drilled holes using #10x¾”
square pan screws. Tighten with a #2 square drive screw
driver or a #2 square bit with a screw gun.
• Repeat this step for the right leg.
Step 2:
• Attach (4) angle brackets to the outer side of the modesty
panel aligning it with the pre-drilled holes using #10x¾”
square pan screws. Tighten with a #2 square drive screw
driver or a #2 square bit with a screw gun.
• Repeat this step for the other modesty panel if it’s double
sided.
Step 3:
• While one person holding the left leg and another the
right one, you will need to align connectors on the left and
right ends of the modesty panel with the connectors on
the left and right legs. Press down on the modesty panel
until it’s fully engaged.
• Repeat this step for the other modesty panel if it’s double
sided.
V051519 subject to change.
Einstein Station
Single & Double Sided Seating
Step 1
Modesty
panel/s
Step 2
Assembling this unit on Step 3 may take up to three
people to help hold both left/right legs and another to
assemble the modesty panels.
Tools Required
• #2 Square drive screw driver OR
• Screw gun
• #2 square bit
Left leg
Connectors
Left leg
Right leg
Step 3

2
wibenchmfg.com 507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Item # Description
1 Laminate top
2 Left leg
3 Right leg
4 Cable grommet hole
5 Modesty panel
6 Base leveler
Part Identifier Key
4
3
6
1
2
5
Part # Description Qty.
0406711 #10x¾” black square pan screw
(Used on angle brackets-brackets) 48
0406829 27mm x 27mm x 50mm angle brackets 12
0406659
0406658
2⁄” cable grommet (Used on modesty panel)
3⁄” cable grommet (Used on right, left or center legs)
1
1 - 2
Einstein Station
Single & Double Sided Seating
Step 4:
• Place top on the left/right legs and modesty panel/s. Align
bottom of the top that have the pre-drilled holes to the
brackets that are located on the legs and modesty panel/s.
Attach the brackets to the top with (2) #10x¾”square pan
screws per bracket. Tighten with a #2 square drive screw driver
or a #2 square bit with a screw gun.
Step 5:
• Place cable grommets into the holes located on the laminate
top.
Step 5
Step 4
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identier Key) Any parts damaged during shipment must be
reported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.