Zamel NC60 User manual

BLUE: GND WHITE: COM
RED: NO/NC
GATE CONTROL MODULE NC60
Thank you for buying this product from Zamel.
Zamel shall not accept any liability for any results of damage and/or accidents
caused by non-intended use of the product.
Before attempting installation of this product, please read and understand the entire
Operating Manual in order to comply with the intended use.
Do not open or tamper with the product without prior authorization. Otherwise your
warranty rights for this product will be void.
SAFETY
• Always follow this Manual for your safety and to prevent damage to the product.
• Do not connect or interface this device with incompatible products. Otherwise
there is a risk of an electrical short circuit, resulting in damage to this product.
• Do not install in highly humid indoor environments. Risk of electrical short circuit
and re!
• Do not attempt to disassemble, repair or alter this product on your own.
Risk of electrocution, damage to the product and/or re!
• Verify that the device is properly connected to the video entry phone system
of the gate. Incorrectly connected wiring will overload and damage the device.
PRODUCT FUNCTIONS
The gate control module can relay control commands from a video entry phone
display to the gate controller: via the display contacts GND and DATA on the P3
connector to the NC06 controller and via the display COM and NO/NC to operate
the gate.
PRODUCT DESCRIPTION
• Communication input from the video entry phone DATA display
• NO/NC and COM control output
• The NO/NC contact can work either in NO or NC mode
• The relay break time is programmable in the advanced settings of the video entry
phone display
TECHNICAL DATA
• Operating temperature: -30°C to +60°C
• Supply voltage: none
• Operating RH: 0% to 95%
• Dimensions: 48 x 25 x 20 mm
• Weight: 15 g
WIRING CONNECTION DIAGRAM
YELLOW: DATA
WIRING PROFILE
• ≤ 50 m (4 x 0.5 mm2)
• ≤ 75 m (4 x 0.75 mm2)
• ≤ 100 m (4 x 1.0 mm2)

GND: Ground:
DATA: Data communication
COM: Gate controller COM contact or GND
NO/NC: Gate open/close command
POWER GATE
ENTRANCE PANEL ELECTRIC CATCH,
12V DC or 12V AC
WARRANTY
24-month commercial warranty by the manufacturer
Reseller’s stamp and signature
with date of sale
1. ZAMEL Sp. z o.o. Gives a 24-month warranty for
the goods it sells.
2. The warranty given by ZAMEL Sp. z o.o. does not cover:
a) mechanical damage caused by transport,
loading/unloading or other circumstances;
b) damage caused by improper installation or operation
of the goods manufactured by ZAMEL Sp. z o.o.;
c) damage caused by any modications
made by the BUYER or any third party to
the sold goods or to the equipment required
for the proper functioning of the sold goods;
d) damage caused by any force majeure
event or another fortuitous event beyond
any reasonable control of ZAMEL Sp. z o.o.;
e) the power supply (batteries) included (if any) with the
device as sold.
3. The BUYER shall make all warranty claims in writing at the point of sale or to ZAMEL Sp. z o.o.
4. ZAMEL Sp. z o.o. will examine each warranty claim as regulated by the applicable provisions of the Polish law.
5. The form of warranty claim resolution, i.e. replacement, repair or refund of the price of purchase, shall
be decided by ZAMEL Sp. z o.o.
6. This warranty does not exclude, limit or suspend any rights of the BUYER arising from the statutory
or regulatory laws concerning implied warranty for defects of sold goods.
Display
J4