Zeiss ATLAS 9000 User manual

To begin:
• Insert the Test Eye (Figure 1) in the slots on the chin rest (Figure2).
• Log into the ATLAS software as the Administrator.
• Leave the password box blank.
• Select Tools from the menu and then select Calibration Check and align the projection head by
centering the crosshairs in the smallest ring of the image displayed (Figure 3).
How can I perform a calibration test on my ATLAS 9000?
ZEISS Quick Help: ATLAS®9000
A calibration test can be performed on your ATLAS 9000 using a calibration tool that is often
referred to as the Test Eye. Below is the 3-step check to perform a calibration test.
Figure 1 Figure 2
Figure 3

Step 1
When the image is aligned and focused, press the button on the joystick to capture the image.
• If the first step fails, clean the front surface of the glass spheres on the Test Eye with a soft cloth and
repeat the first step (Figure 4). Residual dirt or oil may cause failure.
• If the first step fails after cleaning the test eye, call a ZEISS Technical Support Engineer for further assistance.
Step 2
Continue to align, focus and capture the second sphere (center sphere), when prompted.
Step 3
Capture the third and final sphere (sphere on the right end of the Test Eye).
• When you have finished the steps of capturing images for all three spheres on the test eye, a dialog
appears (Figure 5) showing the final results of the complete calibration test.
• Three PASS reports indicate successful calibration with accurate measurement reading of the Test Eye.
• If a FAIL is reported on one or more of the calibration checks, try cleaning the failed sphere with a soft
cloth and repeating the three step process before calling a ZEISS Technical Support Engineer. If needed, you
may order a new calibration tool by contacting ZEISS and asking for a Test Eye (PN 000000-109-4714).
Page 2 of 2
How can I perform a calibration test on my ATLAS 9000? | ZEISS Quick Help: ATLAS®9000
Figure 4
SER.8367 Printed in the USA CZ-XI/MMXVI The contents of this reference guide may differ from the current status of the product in your country. Please contact your regional representative for more information. Subject to change in design and scope of delivery and as a result of ongoing technical development. ATLAS is either a trademark or registered trademark of Carl Zeiss Meditec, Inc. in the United States and/or other countries. © 2016 Carl Zeiss Meditec, Inc. All copyrights reserved.
Carl Zeiss Meditec Inc.
5160 Hacienda Drive
Dublin, CA 94568
USA
www.zeiss.com/med
Carl Zeiss Meditec AG
Goeschwitzer Str. 51-52
07745 Jena
Germany
www.zeiss.com/med
0297
Refer to the ATLAS 9000 user manual Instructions for Use for safe and effective operation of the instrument.
Figure 5