zortrax FEP Film Use and care manual

FEP Film Replacement
SOURCE:
https://support.zortrax.com/inkspire-fep-film-replacement/

Table Of Content
UV Cover Removal 3
Lifting up the Platform 4
Unplugging the Power Cable 5
Resin Tank Removal 6
FEP Film Rack Removal 7
Unscrewing the FEP Film Rack 8
FEP Film Removal 9
FEP Film Rack Cleaning 10
FEP Film Installation 11
Securing the FEP Film Rack, part 1 12
FEP Film Rack Installation 13
Securing the FEP Film Rack, part 2 14
Excess FEP Film Removal 15
FEP Film Cleaning 16
Resin Tank Installation 17
UV Cover Installation 18

UV Cover Removal
Remove the UV cover.

Lifting up the Platform
From the menu, select “Tools,” “Platform” and “Move the platform.” Keep the UP
arrow pressed to lift the platform.

Unplugging the Power Cable
Turn off the printer and unplug the power cable.

Resin Tank Removal
Loosen the two screws that secure the resin tank. Next, remove the tank.

FEP Film Rack Removal
Unscrew the black screws that secure the FEP film rack to the resin tank. Next, separate
the FEP film rack from the resin tank.

Unscrewing the FEP Film Rack
Unscrew the silver screws that secure the two parts of the FEP film rack.

FEP Film Removal
Separate both parts of the rack and remove the FEP film.

FEP Film Rack Cleaning
Clean both parts of the FEP film rack with a paper towel soaked in isopropyl alcohol.

FEP Film Installation
Place the new FEP film between the two parts of the FEP film rack.
The new FEP film does not require unfolding after taking it out of the packaging.

Securing the FEP Film Rack, part 1
In order for the FEP film to be properly tight, you have to create a bulge while securing
both parts of the FEP film rack. To do that, place the FEP replacement jig from the
Starter Kit or an item that is 8 mm [0.3 in] thick underneath the film. Next, slightly tighten
the silver screws in a diagonal order. Once the assembly of the FEP film rack is finished,
fully tighten all the screws.
Remember to press the rack while securing each screw to keep the bulge in the FEP
film.

FEP Film Rack Installation
Put the FEP film rack and the resin tank together.

Securing the FEP Film Rack, part 2
Secure the FEP film rack with the black screws in a diagonal order. Once you finish, fully
tighten all screws.

Excess FEP Film Removal
Cut and remove the excess FEP film from the rack.

FEP Film Cleaning
Clean the outside of the FEP film and the LCD screen with a paper towel soaked in
isopropyl alcohol before installing the resin tank in the printer.

Resin Tank Installation
Install the resin tank in its place and tighten the two screws.

UV Cover Installation
Install the UV cover on the printer.
Powered by TCPDF (www.tcpdf.org)