zortrax M200 Operating manual

Platform Maintenance
SOURCE:
https://support.zortrax.com/m200-platform-maintenance/

Table Of Content
Unplugging the Power Cable 3
Unplugging the Heatbed Cable 4
Platform Removal 5
Cleaning the Platform 6
Unscrewing the Perforated Plate 7
Cleaning the Heatbed 8
Cleaning the Perforated Plate with a Spatula 9
Cleaning the Perforated Plate with Sandpaper 10
Cleaning the Perforated Plate with Acetone 11
Securing the Perforated Plate 12
Platform Installation 13
Plugging the Power Cable 14
Platform Calibration 15

Unplugging the Power Cable
Turn off the printer and unplug the power cable.

Unplugging the Heatbed Cable
Unplug the heatbed cable from the platform. Both big and small connectors need to be
unplugged.

Platform Removal
Remove the platform from the printer.

Cleaning the Platform
Clean the platform from material residues using a spatula.
BE CAREFUL NOT TO DAMAGE THE PLATFORM CONNECTORS.

Unscrewing the Perforated Plate
Unscrew the screws that secure the perforated plate to the heatbed. Remove the
perforated plate.

Cleaning the Heatbed
Remove material residues from the heatbed using a piece of cloth or, if it is necessary,
use a spatula.

Cleaning the Perforated Plate with a Spatula
Turn the perforated plate over and clean it from material remains using a spatula.

Cleaning the Perforated Plate with Sandpaper
Turn the plate over again. Use 320-400 grit sandpaper to smooth down the surface of
the plate.
Be careful not to damage the platform connectors.

Cleaning the Perforated Plate with Acetone
Wipe the perforated plate with a piece of cloth damped in acetone.

Securing the Perforated Plate
Secure the perforated plate to the heatbed with the screws.

Platform Installation
Put the platform back in the printer and plug the heatbed cable in. Both big and small
connectors need to be plugged in.

Plugging the Power Cable
Plug the power cable in.
Turn on the printer and wait until the plate heats up. Then, using a piece of cloth, apply
few layers of Z-ABS juice onto the perforated plate.
Preparing Z-ABS Juice

Platform Calibration
After finishing the maintenance work, the platform needs to be calibrated -> follow the
steps included in this manual: platform calibration.
Powered by TCPDF (www.tcpdf.org)