zortrax M300 User manual

Packing
SOURCE:
https://support.zortrax.com/m300-packing/

Table Of Content
Unloading the Material 3
Unplugging the Power Cable 4
Unplugging the Extruder Cable 5
Disassembling the Side Covers 6
Removing the Platform 7
Lifting up the Heatbed Mount 8
Placing the Foams with Accessories 9
Setting the Extruder in the Right Position 10
Wrapping the Printer 11
Placing the Bottom Cushioning 12
Putting the Printer into the Box 13
Placing the Top Cushioning 14
Packing the Printer 15
Taping the Box 16

Unloading the Material
If the material is loaded into the extruder, select Material and then Unload the material
from the menu. Remove the material from the material guide and remove the spool from
the spool holder. Separate the spool holder from the back of the printer and remove the
material guide from the clamps.

Unplugging the Power Cable
Turn the printer off, unplug the power cable and wait until the printer cools down.

Unplugging the Extruder Cable
Unplug the extruder cable.

Disassembling the Side Covers
Disassemble the side covers.

Removing the Platform
Disconnect the platform cable and remove it from the printer.

Lifting up the Heatbed Mount
Lift up the heatbed mount.

Placing the Foams with Accessories
Put the platform in the foam with accessories and place the foam on the bottom of the
printer.

Setting the Extruder in the Right Position
Move the extruder manually to the end of X axis and then to the end of Y axis so the
extruder is placed at the top right corner of the printer. Put the shipping clips on both
axes.