zortrax M200 Plus Guide

Troubleshooting: Camera
Preview Is Blurred
SOURCE:
https://support.zortrax.com/troubleshooting-camera-preview-blurred/

Table Of Content
Blurry Camera View 3
Unscrewing the Camera 4
Removing the Camera (from the Frame) 5
Unscrewing the Camera's Cover 6
Removing the Camera's Case 7
Recalibrating the Camera's Focus 8
Camera Installation, part 1 9
Securing the Camera's Cover 10
Camera's Installation, part 2 11
Securing the Camera 12
Sharp Camera View 13

Blurry Camera View
To see the preview from the printer’s camera, open Z-SUITE 2 and go to My Devices
panel. Select your printer (it should be connected to a local network) and click Camera
Preview.
If the preview in your printer is out of focus, follow the steps from this manual to adjust
focus to the proper point.

Unscrewing the Camera
Unscrew one screw that secures the camera in the printer’s frame. Use a 2mm Allen
key.

Removing the Camera (from the Frame)
Remove the camera together with its cable from the printer’s frame.

Unscrewing the Camera's Cover
Unscrew the two screws that secure the camera’s back cover. Use a Phillips
screwdriver.

Removing the Camera's Case
Separate the camera from its printed case.

Recalibrating the Camera's Focus
Use tweezers and twist the camera’s lens.
To control focus in the camera, twist the lens either clockwise (if focus is set too far from
the camera) or counterclockwise (if focus is set too close to the camera).

Camera Installation, part 1
Put the camera back in its printed case.

Securing the Camera's Cover
Secure the camera’s back cover with the two screws.