ABB PrimEvo XT100E Manual

TECHNICAL SPECIFICATIONS
MOUNTING INSTRUCTIONS
141N TC242IND04
Self-contained, dedicated to escape route and exit sign.
The product is compliant with EN60598.
Cut the wire for
non-maintained mode
For exit sign only
PrimEvo XT100E Instruction leaflet
ABB B.V.
Bruntcliffe Lane
Morley, Leeds
W.Yorkshire LS279LL, UK
Telephone [phone]
Sales [phone]
Fax [phone]
Email [email protected]
The product is composed with First-fix,
electronic enclosure, diffuser & pictogram.
01 02 03
04 05
Note : If IP65 is needed, use an appropriate cable gland
IP 65
65 / 10
220 - 240Vac - 50Hz
Copyright © 2024 ABB
All rights reserved

INSTALLING AND CONNECTING
141N TC242IND04
INSPECTION AND MAINTENANCE
Emergi-Lite strongly advises annual inspection of your emergency lighting installation.
Maintained Non-maintained
Green LED
EXPLANATION PHOTOMETRIC DATA
BATTERY
PLEASE NOTE!
Carefully read this instruction leaflet before installing or using the luminaire. This leaflet provides important
information about the correct installation, use, maintenance and disposal of this product.
Please observe the following guidelines:
1. The luminaire should only be installed by qualified personnel and the installation must be in accordance
with European installation requirements HD 60364 and additional local regulations.
2. This product may not be modified in anyway what so ever or used for a purpose or in an
environment other than for which it is designed. Failing to observe these guidelines will invalidate the
warranty and the CE-compliance of this product.
3. Before installing the luminaire, the supply must be isolated.
4. The light source in this luminare is non-replaceable.
5. The luminaire should be connected to the voltage 220-240v 50Hz.
A fault will occur when test results for duration no longer meets the requirements indicated for the luminaire.
The luminaire must then be replaced. Please see the label on the batteries for the type required. Given the
technical life of the battery, it is recommended to replace them after 4 years.
Constant voltage is required and the batteries must be sufficiently charged for emergency lighting to
function properly. Failure to observe this requirement can damage the batteries, the lightsource or in
worst-case scenario, the luminaires electronics.