Abicor Binzel iROB 420 User manual

T E C H N O L O G Y F O R T H E W E L D E R ´ S W O R L D .
w w w. bin z el -a bi c or .c om
EN Quick guide iROB® 420
This Quick guide is part of the technical documentation and is only valid in connection with the
operating instructions for the system components. Read and observe all documentation for the
system components.
AEthernet connection
BPower connection
CGround cable connection
DCable assembly connection
EWire feeder connection
FSwitch voltage
A
B
C
D
E
F

EN - 2
iROB® 420
Installation
Switch the main switch to <Off>.
Select the voltage. Switch to <400>
or <480>.
Connect the ground cable to the
welding power source and the
welding table.
Connect the cable assembly to the
welding power source and the wire
feeder and the gas supply.
1
2
3
4

iROB® 420
EN - 3
Connect the connecting cable from
the wire feeder to the welding power
source and the wire feeder.
Connect the Ethernet cable to the
power source and the robot
controller.
Connect the welding power source to
the power supply.
On the teach pendant, start the
software and log in.
Select <Welding Machinery>
in the settings menu and select
<SKS power source>.
5
6
7
8

T E C H N O L O G Y F O R T H E W E L D E R ´ S W O R L D .
www.binzel-abicor.com
Alexander Binzel Schweisstechnik GmbH & Co. KG
Kiesacker • 35418 Buseck • GERMANY
T +49 64 08 / 59–0
F +49 64 08 / 59–191
[e-mail]
BEI.0426.0 • 2024-02-06
System overview
Ground cable
Cable assembly welding torch
Connection cable iBOTone®
Connection cable Operator Box
Connection cable Operator Box
Connection cable Wire feeder
Gas supply*
120 V 15 A*
480 V 30 A 3 Phase*
Connection cable Welding power source
Cable assembly
*External connections:
120 V 15 A Connection: NEMA 5-15 p 15 ft cable supplied
480 V 30 A: Bare end 15 ft cable supplied
Gas supply: Bare end 10 ft hose supplied