AETEK C50-082-30-130 User manual

1. Install the PoE switch in a ventilated and dry place that is free of electromagnetic source, vibration, moisture, and dust.
2. Make sure the ventilation openings on the switch are not blocked.
3. Use CAT5 or 5e UTP/STP cables.
4. AC input (100~240V/AC, 50~60Hz), for a max. consumption of 150/300/430W.
C50-082-30-130 Smart PoE Switch
C50-162-30-250 Smart PoE Switch
C50-242-30-370 Smart PoE Switch
Quick Installation Guide
The C50 Series is a 8/16/24 port 10/100/1000BaseT Web smart PoE switch capable of feeding 15.4/30W (54V max.
per port) power to Power over Ethernet (PoE) devices. It comes with 2x GbE SFP port. The switch is capable of a total of
130/250/370 Watts power budget.
IMPORTANT:
INTRODUCTION
C50-242-30-370 CONNECTION
* 1x PoE switch * 1x Quick Installation Guide
* 2x rack mount ears * 1x power cord (type by the shipped-to area)
PACKAGE CONTENTS
Front Panel Rear Panel
C50-182-30-250 CONNECTION
Front Panel Rear Panel

C50-082-30-130 CONNECTION
Front Panel Rear Panel
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
User name admin
DEFAULTS
System Green ON Power is on and normal.
Green Off The switch is not receiving power.
Red ON An abnormal state, such as exceeding operation temperature, has been detected in the switch.
Link/Act/Speed Green ON The port Status LEDs displaying link status, network activities, and speed on each port.
PoE Green ON The RJ45 port status LEDs display PoE powering statuses on each port.
RJ45 ports
SFP ports
Green ON Port is enabled and link established with a device at the 1000Mbps speed.
Grren Blinking Port is transmitting and receiving data at the 1000Mbps speed.
Amber ON Port is enabled and link established with a device at the 100Mbps speed.
Amber Blinking Port is transmitting and receiving data at the 100Mbps speed.
PoE Mode
RJ45 ports
Green ON Port is enabled and supplying power to PD.
Amber ON An abnormal state detected, such as overload.
LED DEFINITIONS
Task Press time System LED Behavior Port Status LED Behavior
Change LED Mode 0 ~ 2 seconds Green ON LED status will be changed according to the mode
selected
Restart 2 ~ 7 seconds Green blinking All LEDs are off
Restore defaults 7 ~ 12 seconds Green blinking All LEDs stay ON
Mode/Reset Button
AETEK INC.
3F, No.192, Lien-Cheng Rd., Chung-Ho, New Taipei City, 235, Taiwan,R.O.C.
|T:[phone]|W:www.aetektec.com |E:s[email protected].tw
Copyright © 2017 AETEK INC. All rights reserved.
Password admin