Anova L1260 User manual

anovafurnishings.com
888.535.5005 tel
ASSEMBLY INSTRUCTIONS
L1260 6  Terrace Contour Bench
L1261 4  Terrace Contour Bench
TOOLS NEEDED:
Phillips Head Screw Driver•
Level•
4 x
3/8-16 X 2” long
Phillips Truss Head Screw
ASSEMBLY:
The assembly is a two-person operation.
Inspect the shipping container contents for damage and to determine that all components and hardware are present.1.
Place the Bench Legs and the Bench Seat on the2.
shipping packaging or other so surface to avoid
scratching the product.
Use so or padded supports to hold the Bench3.
Seat at the approximate height and orientation of
the assembled bench. While one person steadies
the Bench Seat, the other person positions one
of the Bench Legs at the appropriate end of
the bench. The back rest and the seat look very
similar, so be sure that the contour of the edge of
the Bench Seat matches the design of the Bench
Leg. Reposition the Bench Seat if necessary to get
the proper alignment. When the Seat edge aligns
with the Bench Leg design, the mounting holes
in the Bench Leg will align the threaded holes in
edge of the Bench Seat.
NOTE: Before assembling, it is recommended that a
light oil or petroleum jelly be applied to the screw
threads.
Install one of the Phillips Truss Head Screws4.
through the Bench Leg. Install a Washer on the
end of the Screw before proceeding into the
threaded hole in the Bench Seat. Tighten the
Screw nger tight so that adjustments can be
made later to level the Bench Seat.
Install the second Phillips Screw into the other5.
mounting hole, add a Washer between the Bench
Leg and the Bench Seat, and tighten the Screw
nger tight.
ASSEMBLY HARDWARE:
BENCH COMPONENTS:
2 x Bench Legs 1 x Bench Seat
Shipping Cardboard
or other so surface
Bench Seat
Phillips Screw
Washer
4 x
3/8 SS Washer
L1260
6’ model shown
Bench Leg
Phillips Screw
Washer
Straight edge
indicates backrest
Curved edge
indicates seat
SEAT ORIENTATION

Do not drag the assembled unit across any surface.•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to•
remove surface dirt. Do not clean with a solvent or petroleum based products.
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,•
missing, or broken hardware, and general instability.
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.•
Repairs must be made using only factory authorized parts and methods.•
WARNING
CARE AND
MAINTENANCE
211 North Lindbergh Blvd.
St. Louis, MO 63141
tel: [phone]
web: anovafurnishings.com
11/2012
Repeat this procedure for the second6.
Bench Leg at the other end of the Bench
Seat.
Aer both Bench Legs are attached to7.
the Bench Seat, remove any supports
and tighten the Screws while checking
with a Level. Washer
Phillips Screw
Washer
Phillips Screw
The feet of the Bench Legs feature a .5” diameter surface mount bolt hole for securing the Bench with customer supplied surface mount hardware.
Landscape Brands recommends the use of stainless steel fasteners and following the installation directions supplied with that hardware.
Retighten all hardware two weeks aer initial8.
assembly.