APS iBoard IB-R094 User manual

Customer Support: [e-mail]
Rev. 20211001
1
iBoard
®
iBoard® by APS PART#: IB-R094/R095/R952
READ INSTRUCTIONS CAREFULLY BEFORE START ING
INSTALLATION. REMOVE CONTENTS FROM BOX AND
VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS
RECOMMENDED.
*ROCKER PANEL MOUNT
*NO DRILLING REQUIRED
Item QTY Description Item QTY Description
1# 6Mounting Brackets 4# 12 M6 Large Flat Washers
2# 12 M8 Hex Flange Nuts 5# 12 M6 Nylon Lock Nuts
3# 12 M6X1-20mm Square Head Bolts
2 # 5 #
4 #
3 #
Fastener Size Tightening Torque (ft-lbs) Required
6mm 6-7 √
8mm 16-18 √
10mm 31-32 X
12mm 56-58 X
14mm 92-94 X

Customer Support: [e-mail]
Rev. 20211001
2
iBoard
®
PassengerDriver Front
1# 1#
1#
1#
1#
1#

Customer Support: [e-mail]
Rev. 20211001
3
iBoard
®
STEP 1
Start installation on the driver side of the vehicle. Locate the
driver side front bracket mounting location. Select (1) Mounting
Bracket, install with (2) M8 Hex Flange Nuts. Do not fully tight-
en hardware at this time.
STEP 2
Move to the Driver Side Center & Rear Mounting location. Re-
peat Step 1 to install the Driver Side Center & Rear Mounting
Bracket .
Note: (6) Mounting Brackets are universal.
STEP 3
Select a Running Board. Slip (3) M6x1-20mm Square Head
Bolts into each bottom channel (Fig 2). Carefully position the
Running Board onto the (3) Mounting Brackets.
IMPORTANT: Do not slide the Running Board on the Brackets
or the bottom surface of the board will be damaged. Attach the
Running Board to each Mounting Bracket with (2) M6x1-20mm
Square Head Bolts, (2) M6 Large Flat Washers and (2) M6
Nylon Lock Nuts (Fig 3). Do not fully tighten at this time.
(Fig 2) Slip M6X1-20mm Square Head Bolts Into The
Bottom Channels
M6X1-20mm Square Head Bolts
(Fig 1) Driver Side Front Mounting Bracket Installation
Front
Existing insert
In Body Panel
(Fig 3) Running Board Installed Onto Mounting Bracket
(2) M6X1-20mm Square Head Bolts
(2) M6 Large Flat Washers
(2) M6 Nylon Lock Nuts
(2) M8 Hex
Flange Nuts

Customer Support: [e-mail]
Rev. 20211001
4
iBoard
®
STEP 4
Level and adjust the Running Board and fully tighten all hard-
ware.
Important: Please follow the recommended Tightening Tor-
ques shown in the table on page 1. Don’t over tighten, or
the nuts/bolts will be damaged.
STEP 5
Repeat Steps 1-4 for the other side Running Board installation.
The installation is completed .
Attention
Do periodic inspections to the installation to make
sure that all hardware is secure and tight.
In order to protect your bars/boards, please use only
mild soap/non-abrasive products for cleaning.