Argos 389/5690 User manual

Assembly Instructions - Please keep for future reference
Dimensions
Width - 40cm
Height - 45.8cm
Important - Please read these instructions fully before starting assembly
issue 16/03/15
389/5690
Lamp Table
If you need help or have damaged or missing parts, call the Customer Helpline
Argos = 0345 6400800
The maximum weight of the
children user: 50kgs.
Shelf (67 x 34.9cm)
1
Back (69.8 x 69.8cm)
5
15mm Screw x 22
D
Top & Bottom x 2 (67 x 34.9cm)
3
Wall strap x 1
I
12mm Screw x 1
J
26mm Screw x 1
G
Metal plate x 1
H
Unfinished edge
2
2
3
2
2
1
5
Assembly is complete.
C
c:
5
c: Assembly is
complete.
Self adhesive foot pads x 4
Screw nut x 12
b: Use screwdriver to
turn the screw nut make
the hole be aligned.
2B
X 3
2
b:
B
2
2
Top side
Bottom side
A
A
A
A
2
2
2
1
2
2
2
This parts should be the top shelf
F
G
Shelf x 3 (38.4 x 27.4cm)
2
Back panel x 1 (180 x 40cm)
1
C
26mm Screw x 1
Wall strap x 1
D
12mm Screw x 1
E
F
Wall plug x 1
Side panel x 1 (180 x 27.5cm)
3
Unfinished edge
Unfinished edge
Unfinished edge
Shelf pin x 24
26mm Screw x 1
26mm Screw x 4
Warning: The unit weighs
approximately 20kgs.
Please lift with care.
To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
Back panel x 2 (130.9 x 39.8cm)
6
Glass door x 2 (126.7 x 37.9cm)
7
Phillips screwdriver
(medium & large)
Ruler/tape
measure
Nail x 42
b: Beware that the top
panel will align to .
As shown in drawing.
1
b:
a:
b: Beware that the top
panel will align to .
As shown in drawing.
A
1
a:

1
We do not
recommend the use
of power drill/ drivers
for inserting screws,
as this could damage
the unit. Only use hand
screwdrivers.
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
the following pages.
plastic bags and separate them
into their groups.
Remove all fittings from the
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
During assembly do not stand
or put weight on the product,
this could cause damage.
Assemble the item as close
to its final position (in the same
room) as possible.
Assemble on a soft level
surface to avoid damaging the
unit or your floor.
Parts of the assembly will be
easier with 2 people.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
Regularly check and ensure
•
that all bolts and fittings are
tightend properly.
●Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
●From time to time check that
there are no loose screws on
this unit.
●This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
The maximum weight of the
children user: 50kgs.
Shelf (67 x 34.9cm)
1
Back (69.8 x 69.8cm)
5
15mm Screw x 22
D
Top & Bottom x 2 (67 x 34.9cm)
3
Wall strap x 1
I
12mm Screw x 1
J
26mm Screw x 1
G
Metal plate x 1
H
Unfinished edge
2
2
3
2
2
1
5
Assembly is complete.
C
c:
5
c: Assembly is
complete.
Self adhesive foot pads x 4
Screw nut x 12
b: Use screwdriver to
turn the screw nut make
the hole be aligned.
2B
X 3
2
b:
B
2
2
Top side
Bottom side
A
A
A
A
2
2
2
1
2
2
2
This parts should be the top shelf
F
G
Shelf x 3 (38.4 x 27.4cm)
2
Back panel x 1 (180 x 40cm)
1
C
26mm Screw x 1
Wall strap x 1
D
12mm Screw x 1
E
F
Wall plug x 1
Side panel x 1 (180 x 27.5cm)
3
Unfinished edge
Unfinished edge
Unfinished edge
Shelf pin x 24
26mm Screw x 1
26mm Screw x 4
Warning: The unit weighs
approximately 20kgs.
Please lift with care.
To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
Back panel x 2 (130.9 x 39.8cm)
6
Glass door x 2 (126.7 x 37.9cm)
7
Phillips screwdriver
(medium & large)
Ruler/tape
measure
Nail x 42
b: Beware that the top
panel will align to .
As shown in drawing.
1
b:
a:
b: Beware that the top
panel will align to .
As shown in drawing.
A
1
a:

Components - Panels
Please check you have all the panels listed below
2
If you have damaged or missing components,
call the Customer Helpline Argos = 0345 6400800
Bottom panel x 1 (30 x 25cm)
2
Top panel x 1 (40 x 15cm)
1
Components - Fittings
Please check you have all the fittings listed below
13mm Spring Washer x 1
Tools required
Ruler - Use this ruler to help correctly identify the screws
B
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170
44mm bolt x 1
AC
50mm Double head bolt x 1
D
21mm Metal Washer x 1
E
Metal tube x 1
F
Allen Wrench x 1
The screws length is measured from the head to the point (30mm
screw shown).
The maximum weight of the
children user: 50kgs.
Shelf (67 x 34.9cm)
1
Back (69.8 x 69.8cm)
5
15mm Screw x 22
D
Top & Bottom x 2 (67 x 34.9cm)
3
Wall strap x 1
I
12mm Screw x 1
J
26mm Screw x 1
G
Metal plate x 1
H
Unfinished edge
2
2
3
2
2
1
5
Assembly is complete.
C
c:
5
c: Assembly is
complete.
Self adhesive foot pads x 4
Screw nut x 12
b: Use screwdriver to
turn the screw nut make
the hole be aligned.
2B
X 3
2
b:
B
2
2
Top side
Bottom side
A
A
A
A
2
2
2
1
2
2
2
This parts should be the top shelf
F
G
Shelf x 3 (38.4 x 27.4cm)
2
Back panel x 1 (180 x 40cm)
1
C
26mm Screw x 1
Wall strap x 1
D
12mm Screw x 1
E
F
Wall plug x 1
Side panel x 1 (180 x 27.5cm)
3
Unfinished edge
Unfinished edge
Unfinished edge
Shelf pin x 24
26mm Screw x 1
26mm Screw x 4
Warning: The unit weighs
approximately 20kgs.
Please lift with care.
To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
Back panel x 2 (130.9 x 39.8cm)
6
Glass door x 2 (126.7 x 37.9cm)
7
Phillips screwdriver
(medium & large)
Ruler/tape
measure
Nail x 42
b: Beware that the top
panel will align to .
As shown in drawing.
1
b:
a:
b: Beware that the top
panel will align to .
As shown in drawing.
A
1
a:

Assembly Instructions
Step 1
Attaching bottom panel
Step 1
Attaching bottom panel
and metal tube by
screw . Be ware of the
sequence of the washers
and .
and metal tube.
3
2B
A
C
F
E
2E
A
BC
Step 2
Fitting the bolt
Insert the double head
bolt into top panel .
DD
1
1
The maximum weight of the
children user: 50kgs.
Shelf (67 x 34.9cm)
1
Back (69.8 x 69.8cm)
5
15mm Screw x 22
D
Top & Bottom x 2 (67 x 34.9cm)
3
Wall strap x 1
I
12mm Screw x 1
J
26mm Screw x 1
G
Metal plate x 1
H
Unfinished edge
2
2
3
2
2
1
5
Assembly is complete.
C
c:
5
c: Assembly is
complete.
Self adhesive foot pads x 4
Screw nut x 12
b: Use screwdriver to
turn the screw nut make
the hole be aligned.
2B
X 3
2
b:
B
2
2
Top side
Bottom side
A
A
A
A
2
2
2
1
2
2
2
This parts should be the top shelf
F
G
Shelf x 3 (38.4 x 27.4cm)
2
Back panel x 1 (180 x 40cm)
1
C
26mm Screw x 1
Wall strap x 1
D
12mm Screw x 1
E
F
Wall plug x 1
Side panel x 1 (180 x 27.5cm)
3
Unfinished edge
Unfinished edge
Unfinished edge
Shelf pin x 24
26mm Screw x 1
26mm Screw x 4
Warning: The unit weighs
approximately 20kgs.
Please lift with care.
To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
Back panel x 2 (130.9 x 39.8cm)
6
Glass door x 2 (126.7 x 37.9cm)
7
Phillips screwdriver
(medium & large)
Ruler/tape
measure
Nail x 42
b: Beware that the top
panel will align to .
As shown in drawing.
1
b:
a:
b: Beware that the top
panel will align to .
As shown in drawing.
A
1
a:

Assembly Instructions
Step 3
Fitting the Top panel
Step
Turn the top panel onto
the unit until tighten.
4
Assembly is complete.
If you need help or have damaged or missing parts, call the Customer Helpline
Argos = 0345 6400800
The maximum weight of the
children user: 50kgs.
Shelf (67 x 34.9cm)
1
Back (69.8 x 69.8cm)
5
15mm Screw x 22
D
Top & Bottom x 2 (67 x 34.9cm)
3
Wall strap x 1
I
12mm Screw x 1
J
26mm Screw x 1
G
Metal plate x 1
H
Unfinished edge
2
2
3
2
2
1
5
Assembly is complete.
C
c:
5
c: Assembly is
complete.
Self adhesive foot pads x 4
Screw nut x 12
b: Use screwdriver to
turn the screw nut make
the hole be aligned.
2B
X 3
2
b:
B
2
2
Top side
Bottom side
A
A
A
A
2
2
2
1
2
2
2
This parts should be the top shelf
F
G
Shelf x 3 (38.4 x 27.4cm)
2
Back panel x 1 (180 x 40cm)
1
C
26mm Screw x 1
Wall strap x 1
D
12mm Screw x 1
E
F
Wall plug x 1
Side panel x 1 (180 x 27.5cm)
3
Unfinished edge
Unfinished edge
Unfinished edge
Shelf pin x 24
26mm Screw x 1
26mm Screw x 4
Warning: The unit weighs
approximately 20kgs.
Please lift with care.
To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
Back panel x 2 (130.9 x 39.8cm)
6
Glass door x 2 (126.7 x 37.9cm)
7
Phillips screwdriver
(medium & large)
Ruler/tape
measure
Nail x 42
b: Beware that the top
panel will align to .
As shown in drawing.
1
b:
a:
b: Beware that the top
panel will align to .
As shown in drawing.
A
1
a: