Argos 7592573 User manual

Issue 1 -12/10/17
Width - 51cm
Depth - 96.5cm
Height - 46.5cm
Important - Read these instructions fully before starting assembly
Assembly Instructions - Please keep for future reference 7592573
If you need help or have damaged or missing parts, call the Customer Helpline: 03456400800
For further assistance please visit http://www.argos-support.co.uk/
Dimensions
RONDA CONVERSATIONAL SET

1
Care and maintenance
Safety and Care Advice
Important - Read these instructions fully before starting assembly
• This product is manufactured from
toughened safety glass. In the unlikely
event that the glass fails it will break in to
a large number of small fragments that
may be spread over a wide area. This is
a feature of toughened glass, designed to
remove the risk of Injure from glass
breaking into large shards.
• If the glass is chipped or broken, stop
using the product and consult the
manufacturer or supplier.
• Check you have all the components and
tools listed on page 2.
• Remove all fittings from the plastic bags
and separate them into their groups.
• Keep children and animals away from
the work area, small parts could choke if
swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Do not stand or put weight on
the panels during assembly, this
could cause damage.
• Assembly on a soft level surface to
avoid damaging the unit or your floor.
• Parts of the assembly will be easier
with 2 people.
• Dispose of all packaging carefully and
responsibly.
•Do not sit or stand on this table.
• Do not place very hot or very cold items
on the glass.
•Warning: The unit weighs approximately
9.1 kgs. Please lift with care.
!
• Wash frame parts with mild soap and
water, rinse thoroughly, and dry completely.
Do not use bleach, acid, or other solvents
on the frame parts.
• Wash glass with mild soap and water,
rinse thoroughly, and dry completely.
• Do not use washing powders or any
abrasive substances which may scratch
the surface.
• Inspect and tighten all bolts and fasteners
on a regular basis to ensure the proper
performance and safety of your table.
• When moving the table, lift. Do not drag
this table.
• We recommend the use of furniture
covers when not in use.
• In order to prolong the life and
beauty of your table, we recommend that
it be stored in a dry and protected area
when not in use.
• Do not use the glass as chopping
surface. Do not strike the glass with
hard or pointed items.

Note: The quantities below are the correct amount to complete the assembly.
4mm Hex Key 10 & 13mm Nut Wrench Screwdriver (Not provided)
D
ST4.2 x 12 Screw x 4 M6 x 55mm Bolt x 4
Components - Fittings
Please check you have all the fittings listed below
2
A B C
D E
Components - Parts
Please check you have all the parts listed below
Table Top x 1
1Leg x 4
2Center Connector x 1 3
Tools required
M6 x P1.0 Plastic Nut x 4
Ruler - Use this ruler to help correctly identify the screws
55
D10 Washer x 4
D13 Washer x 4

Step 1
Step 2
3
Assembly Instructions
Place the table top onto
a non-abrasive surface,
such as a carpet, with its
underside facing upwards.
Insert the legs into the
plastic holders attached on
the underside of the table
top rim. Fix them
together by using screws
.
1
2
2
2
2
2
2
2
3
2
A
1
2
1
During assembly do not lay
the glass directly onto hard
or rough surfaces. We
recommend laying the
glass on a blanket or
cardboard during assembly.
You could even use the box.
A
DE
BC
Fix the center connector
to the middle of the legs
by using bolts , washers
( and ) and
plastic nuts
. Make sure that all of the
bolts have been tightened
completely.
B
C D
E
3
2

Warning: Don't detach the plastic support
from the table frame! It is for glass support!
!
Assembly Instructions
Assembly is completed.
4
Step 3
If you need help or have damaged or missing parts, call the Customer Helpline: 03456400800
For further assistance please visit http://www.argos-support.co.uk/
Retailer: Argos
Address: 489-499 Avebury Boulevard Saxon Gate West, Central Milton Keynes Bucks, MK9, 2NW
Turn the table to its upright
position.
Note:
To use an umbrella with
this table, remove the
center plug and put the
umbrella pole through the
table top and center
connector ring.
When lifting or moving the
product, ask for someone
to lend a hand, trying to
move a product on your
own can lead to accidents.