Argos 700-3024 User manual

700-3024
PARTS LIST
A. Posts (8)
B. Shelves (5)
C. Long Apron (10)
D. Short Apron (10)
Shelf Dimensions: 183H x 91.5W x 45.8D cm
Assembly & User Instructions - Please keep for future reference
Shelving Assembly Instructions
Tools Required:
A Mallet (not included)
Important
MAX. Load per Shelf: 175kg
MAX. Load for whole unit: 875kg
Important:
Be sure to line up and match
hole pattern on all posts prior to
assembly.
• Place post upright, using cardboard
or other safeguard beneath post to
protect floor.
• Insert tabs on long shelf support
apron into slots on post.
• Press on tabs with fingers to guide
into slots.
• Push down or gently tap apron
corner with rubber mallet to extend
tabs through slots.
• It is recommended that the bottom
shelf aprons be placed in the second
and third slots from the bottom.
• To ensure stability of the vertical unit,
do not place bottom shelf aprons any
higher than the sixth slot.
Next, insert tabs of a short
apron into the front post,
creating a “tripod.” Then
alternate insertion of support
aprons with posts.
Componentseference
IMPORTANT SAFETY WARNINGS
• Please read the instructions before assembly.
• 2 people are recommended for assembly.
• BE CAREFUL of sharp edges when assembling.
• DO NOT stand on this product or use as a ladder.
• DO NOT alter this product in any manner that is
not intended. This may cause product damage or
personal injury.
• Position the product on a level surface.
• The maximum loaded weight for each shelf is no
more than 175kg. Evenly distributed.
• When loading shelves, place heavier items on the
lower shelves, distributing the load evenly.
• Fasten the unit to the wall whenever possible with
proper fasteners (not furnished).
• Check the suitability of the wall type and to check
that the fastening devices will be able to withstand
the forces generated. Consult a competent person if
in doubt.

700-3024 Issue 1 – R.W. 22-03-10
Place shelves starting at
the bottom as you build
each layer. Gently tap the
top of the shelf around
each corner with a rubber
mallet until tabs are flush
with slots.
First and second slots
recommended
Optional Location
3
This unit can be assembled upright
(vertically) or side-by-side (horizontally).
For vertical assembly
• The posts are attached using a shelf
support apron at the mid-level of the unit.
• To attach using the aprons, begin with a
short apron.
• First insert top apron tab into the bottom
slot of the upper post section, as shown in
illustration A, and then insert the lower
apron in the top slot of the lower post
section as shown in illustration B.
• Repeat this process at the other end of
the short apron.
• Insert a long apron by again inserting the
lower tab into the top slot of the lower post
section and top apron tab into the bottom
side of the upper post section (illustrations
C, D).
• If needed, the unattached end of the
long apron can be rested on the lower
post section, joining of lower and upper
post sections using the aprons until all are
installed.
IMPORTANT NOTICE
• When assembling your unit it is recommended that you place the top
shelf aprons in the first and second slots from the top.
• When moving assembled unit, always handle by the lower half. Recheck
all apron tabs/slots being sure they are securely seated.
• To ensure stability of the unit, do not place the top shelf aprons any lower
than the sixth slot. This applies to both vertical and horizontal assembly.
For Horizontal Assembly
Care and Maintenanceference
• Only clean using a damp cloth and
mild detergent, do no use bleach or
abrasive cleaners.
• This product should not be discarded
with household waste. Take to your
local authority waste disposal centre.
• From time to time check that there
are no loose fitting or parst on this
unit.
• Do not overload the shelf.
Argos, 489-499 Avebury Boulevard, Saxon Gate West,
Central Milton Keynes, MK9 2NW, United Kingdom