Arjo AtmosAir Velaris User manual

Run/Standby button and light
The Run/Standby button switches the pump between Run mode and Standby
mode.
In Run mode the light is lit.
For Standby mode, press and hold the button for two seconds. The light turns
off.
Lock button and light
To lock the control panel, press and hold the Lock button for 2 seconds. When
locked the light turns on.
To unlock all control panel buttons, press and hold the Lock button for two
seconds. When unlocked the light turns off.
Audio off light
The Audio off light turns on when the Audio notications and alarms have
been permanently disabled
Weight select buttons and light
The default weight is set and lit at 100 kg (220 lb).
• Press the - button to reduce the patient weight.
• Press the + button to increase the patient weight.
40 60 80 100 130 170 210 250 350 450
kg
Skin IQ
AtmosAir Velaris
40 60 80 100 130 170 210 250 350 454
kg
Skin IQ
AtmosAir Velaris
40 60 80 100 130 170 210 250 350 450 kg
Repeater light
08.AAV.01EN_01 • 06/2021 • Page 1/2
QUICK REFERENCE GUIDE - CONTROLS
AtmosAir Velaris

Audio alarm pause button and light
Press the Audio alarm pause button to silence the audible alarm for 15
minutes, the light turns on.
Press the button again to cancel the alarm pause.
Power fail light
If a power failure is detected the Power failure light turns on and an alarm
sounds.
Active (alternating) therapy is not possible during power failure conditions.
System fault light
If an internal fault of the pump is detected during Built-In Self-Test (BIST) or
during therapy, the System fault light turns on and an alarm sounds.
Low pressure light
If the mattress fails to achieve the target pressure, the Low pressure light turns
on and an alarm sounds.
Skin-IQ light
The Skin-IQ lights turns on when a Skin-IQ coverlet is connected to the Skin
IQ power outlet port.
Skin IQ
ArjoHuntleigh AB
Hans Michelsensgatan 10
211 20 Malmö, Sweden
www.arjo.com 08.AAV.01EN_01 • 06/2021 • Page 2/2