Arjo Miranti User manual

Removing visual residue
Position the hygiene lift over the bathtub
and lower it.
Miranti: Remove headrest, thigh support cushion,
patient security grip and safety belts.
Bolero: Remove mattress and safety belts.
Alenti: Remove backrest and safety belt.
Calypso: Remove seats, seat insert, backrest and
safety belt.
Place the accessories at the bottom of the bath tub.
Clean from visible residue using a cloth soaked in water or by
showering with water and scrubbing with a brush. Clean the
hygiene lift from the top and move downwards.
Clean all removed parts.
21 3
NOTE
The cleaning and disinfection procedure is illustrated with Miranti and an integrated disinfection
system as an example.
WARNING
To avoid eye and skin damage, always use protective glasses and gloves. If contact occurs rinse with
plenty of water. If eyes or skin becomes irritated, contact a physician. Always read the Instructions for
Use and the Safety Data Sheet (SDS) of the disinfectant.
To prevent cross-contamination, always follow the disinfection instructions in the Instructions for Use.
To avoid eye or skin irritation, never disinfect in the presence of a patient.
Continue with the steps on the next page
Clean and disinfect daily.
Clean and disinfect before next patient.
Accessories needed:
• Protective gloves
• Protective glasses
• Spray bottle with disinfectant (if integrated
disinfection system is not available)
• Spray bottle (or shower handle) with water
• Cloths - wet and dry
• Disposable towels
• Soft-bristled brush
• Long-handled, soft-bristled brush
QUICK REFERENCE GUIDE - CLEANING AND DISINFECTION
Miranti, Bolero, Alenti, Calypso
08.CE.06EN_1 • 06/2020 • Page 1/3

Cleaning
!
Wet a new cloth with water and
remove all traces of disinfectant
on other areas. The cloth should
occasionally be rinsed in running
water.
If all disinfectant cannot be removed, spray
with water on the affected part and wipe off
with disposable towel until all disinfectant is
removed.
910
Soak a cloth in disinfectant and
wipe all other areas.
8
Spray disinfectant on the hygiene lift and on all removed
parts.
Use a spray bottle with disinfectant or use the bath’s
integrated disinfection system.
Scrub thoroughly with a brush soaked in disinfectant, especially on
handles, hand control, hinges and the underside of the hygiene lift.
Shower with water (approx. 25 °C
(77 °F)) or spray with water and wipe with
a clean cloth.
56
7
Put on protective gloves and
glasses.
4
Read the separate
instructions for
disinfection system
and disinfectant
used
Continue with the steps on the next page
08.CE.06EN_1 • 06/2020 • Page 2/3

Disinfection
!
Let all parts dry.
If all disinfectant cannot be removed, spray
with water on affected parts and wipe off with
disposable towel until all disinfectant is removed.
Soak a cloth in disinfectant and wipe all other
areas.
Allow a disinfection time according to the instructions of
disinfectant.
Shower or spray with water and wipe with a clean
cloth to remove all traces of disinfectant from the
hygiene lift, chassis and all removed parts. The cloth
should occasionally be rinsed in running water.
Spray disinfectant on the hygiene lift and on all
removed parts.
11 12 13
14 15 16
?
08.CE.06EN_1 • 06/2020 • Page 3/3
ArjoHuntleigh AB
Hans Michelsensgatan 10
211 20 Malmö, Sweden
www.arjo.com