baby&child BELLINA TWIN/FULL BED User manual

A HEADBOARD
BSIDE RAILS
CFOOT BOARD
D SET OF BED SLATS
E LEG
Customer Service - If you are missing parts or have any question about this product please contact us at
1-800-762-1751
NO.
1
2
3
4HEX NUT
THREADED ROD
CURVED WASHER
LOCK WASHER
QTY.
8 PCS
8 PCS
8 PCS
8 PCS
5WRENCH 1 PC
IMPORTANT
We recommend assembly by two or more people.
BELLINA TWIN/FULL BED
PART LIST
WARNING
: ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL PARTS,
SHARP POINTS AND EDGES
HARDWARE LIST
Page 1 of 2
6SCREW 26 PCS
DESCRIPTION
TOOLS NEEDED
Phillips Head Screwdriver (not included)

ASSEMBLY INSTRUCTIONS:
Thank you for choosing this quality product.
Be sure to check all packaging materials
carefully for small parts that may have
become loose during shipment and place all
parts on a non-abrasive surface.
The bed is composed of several components:
The headboard, side rails, foot board, bed
slats, support slat and leg. Determine the
intended location and ensure there is enough
space to work with and fully read these
instructions before starting assembly.
STEP #1:
Gently lay down the headboard (A) and
footboard (C) on a clean and non-abrasive
surface.
NOTE: on the bottom of both headboard (A)
and footboard (C) are holes with
pre-installed nuts that correspond with the
threaded rods pre-installed in the legs (E).
STEP #2
Align and insert the threaded rods of the legs
(E) into the holes and turn clockwise to
tighten as illustrated in FIGURE 01.
STEP #3:
Place the headboard (A) upright in the
position you wish the bed to be in when fully
assembled. The headboard bed fast hardware
should be facing the inside, toward the
mattress. Secure the threaded rods (1) to the
fixed nuts in the headboard (A) by simply
turning manually. Raise the side rail (B) up
and place the rods (1) to align with the bore
holes on the end of the side rails (B). Put the
side rails (B) up against the headboard (A) so
the threaded rods go through the bore holes.
Insert curved washers (2) and lock washers
(3), place hex nuts (4) on threaded rods (1)
and tighten hex nuts (4) with wrench (5), as
illustrated in FIGURE 02.
FIGURE 01
FIGURE 02
Page 2 of 3
A/C
E

STEP #4:
Repeat the above procedure with the other
side rail (B) to attach it to the headboard
(A), and then repeat to connect side rails
(B) to the footboard (C).
STEP #5:
On inside face of both side rails (B) are
cleats and wooden stoppers, designed to
hold the set of slats. Set the bed slats (D)
into the cleats of the side rails (B) and
secure the slats with Phillip screws (6)
provided. Please see FIGURE 03 and
FIGURE 04.
FIGURE 03
FIGURE 04
Page 3 of 3
Thank you for your purchase
www.rhbabyandchild.com