baby&child EDIE TALL UPHOLSTERED BED User manual

NO. Qty
1
2
DESCRIPTION
A [1] Headboard
B [2] Side Rail
Screw(3cm) 30 Pieces
C [1] Footboard
2 Pieces
D [1] Slat Roll
E [1] Center Support Slat
F [1] Center Support Slat Foot (with adjustable glide)
Phillips Screwdriver (not included)
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
1. Stand the Headboard (A) upright and attach Side Rails (B), as shown in Diagram I.
2.
Repeat above procedure to attach the Footboard (C), as shown in Diagram II.
3. Attach the Center Support Slat Foot (F) to the Center Support Slat (E), as shown in Diagram III.
Place the Slat Roll (D) into the cleats on the inside of the Side Rails (B).
Screw the ends of the slats to the cleats using Screws (1), as shown in Diagram V.
Page 1 of 2
5.
Screw(5cm)
4. Attach the Center Support Slat (E) to the U shape wood blocks on Headboard (A), tighten with Long Screw (2),
1 Piece
3 Allen Key
PARTS INCLUDED
TOOLS NEEDED
ASSEMBLY INSTRUCTIONS
EDIE TALL UPHOLSTERED BED
as shown in Diagram IV.
& Allen Key (3),

Thank you for your purchase
Page 2 of 2
www.restorationhardware.com
F
A
C
D
1
Diagram III
Diagram IV
Diagram I
B
Diagram V
Diagram II
E
CARE INSTRUCTIONS
1. Spot clean only with a soft, damp cloth.
2. Do not use abrasive cleanser.