Belson Outdoors LB6WB-P User manual

Model # LB6WB-P Instructions Sheet
www.belson.com
LANDMARK BENCH WITH BACK
627 Amersale Drive
Naperville, IL 60563
Phone: [phone]
Fax: [phone]
[email protected]

www.belson.com
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED.
FP - FASTENER PACK
( 1 ) - ONE FASTENER PACK
B - BENCH
( 3 ) - THREE BENCH ENDS
A - BACK BENCH BOARD
( 1 ) - ONE BACK BENCH BOARD
B - SEAT BENCH BOARD
( 3 ) - THREE SEAT BENCH BOARDS

www.belson.com
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL FASTENERS ARE INCLUDED.
24 - #12 X 3” FLAT HEAD PHILLIPS SCREW
ALSO NEED FOR THIS ASSEMBLY WILL BE THE FOLLOWING MATERIALS:
1 - #3 PHILLIPS DRIVE BIT

www.belson.com
STEP #1:
STAND ( 1 ) ONE BENCH END UPRIGHT AND PLACE ( 1 ) ONE BENCH BOARD ON POSITION 1 BEING
SURE TO ALIGN THE PRE-DRILLED HOLES TO THE PILOT HOLES IN THE BENCH END. AFTER THE
HOLES ARE PROPERLY ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 3” FLAT HEAD PHILLIPS SCREW IN THE
TOP PRE-DRILLED HOLE.
NOTE: DO NOT TIGHTEN BOLTS COMPLETELY. THIS WILL BE DONE IN A LATER STEP.
FIG #1:
IN ORDER TO MAKE THE ASSEMBLY OF THIS LANDMARK BENCH EASIER WHILE GOING THROUGH
THE ASSEMBLY PROCESS THE BOARD POSITIONS ARE NUMBERED AND WILL BE REFERENCED
IN LATER STEPS.
#12 X 3” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #2:
STAND THE OTHER ( 2 ) TWO BENCH ENDS UPRIGHT, ONE AT A TIME, AND PLACE THE BENCH BOARD
ALREADY ATTACHED TO THE FIRST BENCH END, ON POSITION 1 BEING SURE TO ALIGN THE PRE-DRILLED
HOLES TO THE PILOT HOLES IN THE BENCH END. AFTER THE HOLES ARE PROPERLY ALIGNED, FASTEN
WITH ( 1 ) ONE #12 X 3” FLAT HEAD PHILLIPS SCREW IN THE TOP PRE-DRILLED HOLE OF THE BACK
BENCH BOARD
NOTE: DO NOT TIGHTEN SCREWS COMPLETELY. THIS WILL BE DONE IN A LATER STEP.
#12 X 3” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #4:
PLACE ( 1 ) ONE SEAT BENCH BOARD ON POSITION 4. REPEAT STEPS 1 - 3 TO ATTACH. USE ( 1 ) ONE
#12 X 3” FLAT HEAD PHILLIPS SCREW PER HOLE TO FASTEN.
STEP #3:
ALIGN BOTTOM PRE-DRILLED HOLES TO THE PILOT HOLES IN THE BENCH END. AFTER THE HOLES ARE
PROPERLY ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 3” FLAT HEAD PHILLIPS SCREW PER HOLE.
NOTE: BE SURE TO TIGHTEN SCREWS COMPLETELY AFTER THIS STEP.
#12 X 3” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #5:
REPEAT STEPS 1 - 3 TO ATTACH BENCH BOARDS ON POSITIONS 2 & 3. USE ( 1 ) ONE #12 X 3”
FLAT HEAD PHILLIPS SCREW PER HOLE TO FASTEN.
#12 X 3” FLAT HEAD
PHILLIPS SCREW