BluDot SHALE Series Quick start guide

WWW.BLUDOT.COM SHALE WALL MOUNT rev00 - PAGE 1 OF 2
SHALE
Assembly Notes
WALL MOUNT
CARE
Clean with a
slightly damp, soft
cloth. To remove dirt
and fingerprints, use a
quality cleaner formulated
for wood furniture. Wipe
completely dry with
a soft cloth in the
direction of the
wood grain.
NO CURSING
REQUIRED.
HARDWARE
WALL BAR
x1
8027
1
*
*
*
*
*
Installation of the Wall
Mounted Shale is not for
the faint of heart. We
recommend professional
installation to ensure
proper mounting.
To determine the hardware
best suited for your type of
wall and anticipated load,
consult your local hardware
professional.
DESIRED HEIGHT
1-1/4in.
Remove top drawer
for easy installation.
Open drawer and place
hands underneath front
of drawer, pulling on
levers on each end.
Attach wall bar using
outermoust screw
holes first then find
wall studs and attach
using closest holes.

WWW.BLUDOT.COM SHALE WALL MOUNT rev00 - PAGE 2 OF 2
2
3
Cabinet hanger
bracket
will fit over
wall bar.
Front adjustment
screw changes the
yaw of the console.
Rotate screw clockwise
to move the console
closer to the wall.
wall bar
Bottom adjustment
screw changes the
pitch of the console.
Rotate screw
clockwise to move
the console up.
TO MAKE SURE EACH
OF THE THREE CABINET
HANGERS WITHIN THE CONSOLE
LATCH OVER THE WALL BAR,
EXTEND THE CABINET HANGER
BRACKETS BY TURNING THE
FRONT ADJUSTMENT SCREW
COUNTER CLOCKWISE.
TO EFFECTIVELY CHANGE
THE POSITION OF THE CON-
SOLE, ADJUSTMENT SCREWS
MUST BE CHANGED ON
ALL THREE OF THE CABINET
HANGERS. USE A LEVEL TO
CHECK FOR SQUARENESS. IF
SAGGING OCCURS ADJUST
CENTER CABINET HANGER
1
2
1
2
Visually inspect
that each cabinet
hanger bracket is
latched to the
wall bar.