Bosch Spexor User manual

spexor
Original instructions
English

English | 2

Contents
English | 3
About this manual4
Safety5
Description11
Commissioning21
Operation28
Monitoring29
Alarm functions37
Charging the battery41
Updating42
Storage45
Maintenance and service46
Legal notice52

English | 4
About this manual
Other applicable documents
Quick Start Guide from the scope of supply
Presentation of information
Hazards and instructions are marked as follows in this user
manual:
– Note –
Hazardous situation that may result in damage to
property or the environment
▷Marking of an instruction requiring action

English | 5
Safety
▷Read all safety warnings and instructions. Failure to
observe the safety warnings and instructions can result in
short circuits or malfunctions.
▷Carry out all work only according to the complete
operating instructions.
▷Only operate spexor if it is in a technically flawless
condition.
▷These operating instructions and Quick Start Guide must
be kept available at all times. Don’t throw either one
away!

English | 6
Safety
Usage in compliance with the intended use
The mobile alarm device spexor monitors its environment
with various sensors and triggers an alarm in case of
deviations. spexor should only be used in closed rooms or
vehicles and only in dry environments.
spexor may only be used in a normal household envi-
ronment or in vehicles and under no circumstances in
particularly critical areas. spexor is not an alarm system,
burglar system or fire alarm system, especially not in the
sense of the relevant standards. spexor is neither certified
as a smoke alarm device in accordance with standard EN
14604: 2005/AC:2008 nor is it suitable for this purpose. The
air quality sensor installed in the spexor is not a calibrated
measuring device for high-precision measurements.

English | 7
Safety
Hazards
No modifications to the alarm device! Modifications to
the alarm device can result in hazardous damage to the
battery, short circuit and malfunction. Do not modify the
alarm device in any way. Do not open the alarm device. The
alarm device does not contain any components that you can
maintain or replace.
Fire hazard! Charge the battery of the alarm device
only with the charger supplied by the manufacturer. If a
charger designed for a particular type of battery is used with
other batteries, then there is a risk of fire.

English | 8
Safety
Hazardous vapors or liquids! If the device and battery
are damaged, vapors or flammable liquids may escape
from the battery. The vapors can irritate the respiratory
system. Ventilate the area with fresh air and seek medical
help in case of complaints. Leaking battery fluid may cause
skin irritation or burns. Avoid contact with it. In case of acci-
dental contact, rinse the affected body part with water.
Exposure to fire and heat! Excessive heat can damage
the battery or sensors. There is a risk of explosion or short
circuit. Protect the alarm device from heat and keep it away
from heat sources such as radiators or stoves and from
open flames. Observe the operating and storage tempera-
ture ranges specified in the Technical Data on page 20.

English | 9
Safety
Loud alarm signal! If an alarm is triggered, the audio
module of the alarm device emits an acoustic signal
that is loud enough to damage your hearing. Do not hold
the alarm device directly against your ears or those of other
people. Never use the alarm device as a baby monitor!
Penetrating moisture! The alarm device is not pro-
tected against moisture, water or liquids. Penetrating
moisture can destroy the alarm device. Keep the alarm
device away from water or other liquids.

English | 10
Safety
Damaged or entangled charging cable! Damaged or
tangled charging cables can result in a short circuit.
Do not misuse the charger cable for other purposes, such
as carrying or hanging the alarm device or to pull the plug
from the electrical socket. Keep the charger cable away from
heat, oil, sharp edges, tools and other machines.
Hazards caused by unauthorized use! The nature of the
device’s design and components can result in hazard-
ous situations if the alarm device is used by unautho-
rized persons. Store unused alarm devices out of the reach
of children. Do not allow persons to use the alarm device
who are not familiar with the device or who have not read
these operating instructions.

English | 11
Scope of delivery
–Alarm device spexor
–Power supply unit
–USB charger cable
–Operating
instructions
–Quick Start Guide
with QR code
▷Check that all items have
been delivered. Do not
use damaged parts.
Description

English | 12
Description
Components
1Infrared motion sensor
2LED array bar
3ON/OFF switch
4Micro-USB port
5Sound bar, behind it there are further sensors
(e.g. pressure, sound)
6Keypad with LED

English | 13
13 2
546

English | 14
Description
The LEDs in the LED array bar indicate the following states:
Blue Continuous light-up: Smartphone and app
are connected to spexor via Bluetooth®.
White Short continuous light-up: Switch on at the
ON/OFF switch.
Short flashes: spexor is still switched on if
it is touched or moved while monitoring is
deactivated.
Short flashes every 30 seconds: spexor is
active when monitoring is activated.
Three flashes sequentially emitted all
around the LED array bar: Power supply
unit has been detected and charging begins.

English | 15
Description
Green Six flashes sequentially emitted all
around the LED array bar: spexor boots up
after switching on.
Pulse for 60 seconds: Indicates sensor
calibration after monitoring is activated
as well as the remaining time to leave the
monitored room.
Red Flashing: The alarm is triggered.
Short continuous light-up: Switch off at the
ON/OFF switch.
Depending on the viewing angle, the white light may appear
somewhat violet.

English | 16
Description
Function
spexor is a mobile danger warning device. Its sensors
monitor the environment in closed rooms, e.g. at home, in
the garage, in the garden shed, in the mobile home or in
vehicles with regard to pressure, sound and movement,
vibration, air, temperature, brightness, humidity, fire-related
gases, hazardous gases (e.g. carbon monoxide) and air
quality. For intrusion detection, spexor continuously eva-
luates a combination of the various sensors. If deviations
are registered, spexor triggers an alarm.
Some of the in-built sensors can only be unlocked with
future updates.

English | 17
Description
spexor uses standard technologies for cellular mobile tele-
phony and wireless data transmission: Bluetooth®, WLAN
and GSM (2G). It can also ascertain its location via GPS
data.
If you are nearby, spexor establishes a direct connection to
your smartphone and the app via Bluetooth®. This is only
used during setup, but not for activating or deactivating
monitoring or for sending alarm messages via your smart-
phone. This saves mobile phone time and conserves battery
power.

English | 18
Description
No matter where spexor is installed and how far away from
your smartphone, it first sends alarm messages via the
mobile phone network (with the integrated mobile phone
card) to the automated Bosch data processing back-end.
From there, the message is forwarded to your smartphone.
At home this is done via WLAN to conserve the battery
power of spexor. At all other locations messages are sent via
mobile phone 2G technology.
The rechargeable battery of spexor lasts for several weeks
on a single charge, and even longer if operated using WLAN
exclusively.

English | 19
Description
Technical Data
–Batteries: Lithium ion rechargeable battery pack
with 10 Ah, 3.7 V
–Charging current: 1.6 A at 5 V
–Battery self-discharge: approx. 4% per month
–Maximum charging time: 8 h
–Supported smartphone operating systems (status 2020):
iOS 12.0 or higher, Android 8.0 or higher
–Mobile phone network: GSM, 2G (D2 Vodafone)
–Frequency band, maximum transmission power:
Bluetooth®: 2.4 GHz, +19 dBm TX power
WLAN: 2.4 GHz, +20 dBm TX power
GSM: 900 and 1800 MHz, +33 dBm ± 2 dB
GPS: GNNS can only be received, GPS: L1 band,
GLONASS: G1 band

English | 20
Description
–Localization: GPS
–Sensor detection: up to 5 m radius for motion detection
–Audible alarm signal: up to 90 dB(A)
–Permissible ambient temperature during operation and
storage: –10 … +60 °C
–Permissible ambient temperature when charging the
batteries: 0 … +40 °C
–Weight: 320 g (11.3 oz)
–Dimensions: Height 115 mm (4.5 inches),
largest diameter 70 mm (2.75 inches)
–Type of protection: IP 20