Bretford Explorer ETCM-SB User manual

ExplorerTM TV Cart
Assembly Instructions
Included:
ETCMHD-SB will also include:
ETCM-SB
ETCMHD-SB
031-11241
Rev .B –
12.08.22

Assembly Steps:
1. Unbox and Remove Packaging
Unfold end flap on bottom tray
and roll Base off pallet
Remove remaining support pieces
Cut off straps and
remove top tray
Lift the outer wrap up and off
Remove TV Mount & center
internal supports
Slide the Handle up and out
(for model ETCMHD-SB)
Slide the Upright up and out

2. Attach Upright to Base
Push the “ON” tab down on the two
locking casters so frame does not move.
Attach using flat washers, lock washers and 1” screws, then tighten with wrench.
Install the Upright on the Base by
sliding it onto the two posts.
Hardware:
030-2302 (x4) – Hex Head Screws
030-2303 (x4) – Lock Washers
010-8837 (x1) – Hex Wrench

3. Install TV Mount to Upright
Hardware:
030-2322 (x4) – Carriage Bolts
030-2323 (x4) – Lock Nuts
010-8837 (x1) – Hex Wrench
Attach with Carriage Bolts and Nuts,
starting with the lower holes first.
Select the tilt of the monitor.
Line up bottom of TV Mount with
one of the two sets of holes.
NOTE: It is recommended that 75”+
monitors go on the lower holes to
prevent hitting the top of the doorway
Secure the top of the mount with
Carriage Bolts and Nuts, then tighten all
four with wrench.

4. Mount your TV
Caution: Two person install
Caution: Display not to exceed 200 pounds
Caution: Ensure caster brakes are locked
Caution: Do not overtighten set screws
Hardware:
M6 or M8 Set Screws (x4)
M6 or M8 Set Screws (x4)
M6 or M8 Set Screws (x4)
Determine the hole size on the
back of the TV to be mounted –
M6 or M8 – and insert the
appropriately sized set screws.
Secure the TV to the Mount
with washers, lock washers
and wing nuts (M6 or M8).

5. Manage the Power Cord
2. Slide the Velcro through the loops, route your power cord and
secure it using the straps.
1. There is a series of small holes on each side of the frame for locating
the cable management loops. Install loops with push rivets.
Hardware:
030-2249 (x3) – Cable Management Loop
030-2244 (x3) – Push Rivet
031-8122 (x3) – Velcro Strap